ECR 4 Kids ELR-0450-A User manual

Hex Screws (12)
Use the Hex Tool.
Use a
Phillips
Screwdriver.
Batch ID
located underneath.
Middle Shelf (1)
Top Panel (1)
Left & Right Side Panels (1/1)
Parts List
A
B
C
D
E
F
G
BEFORE ASSEMBLING, MAKE
SURE YOU HAVE ALL THE PARTS
Phillips Screws & Casters (16/4)
Bottom Shelf (1)
Back Panels (2)
A1 A2
G1 G2
Install the Right Side Panel
2
Two Shelf Storage Cabinet
with Back
Model# ELR-0450-A
Adult Assembly Required.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean or pull on
unit for support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
WARNING:
TOOLS INCLUDED
Hex Tool (1)
TOOLS NEEDED
Phillips Screwdriver
Install Right Side Panel (A2) on to the Top Panel (B), Middle Shelf (C) & Bottom Shelf (D)
with six Hex Screws (F) using the Hex Tool.
Note: The grooves on the Top Panel, Middle and Bottom Shelves are away from the ground.
See Next Page
San Diego, CA 92110 USA
www.ecr4kids.com
Children climbing on furniture
can lead to death or serious
injury due to tipping. Secure
unit to wall using appropriate
hardware.
1Install the Casters onto Bottom Shelf
Batch ID Sticker
Install the four Casters (G2) into the pre-drilled holes on the underside of the Bottom Shelf (D),
with four Phillips Screws (G1) per caster, using a Phillips screwdriver.

3Insert the Back Panels
4Install the Left Side Panel
Slide both Back Panels (E) into the grooves on the Top Panel (B), Middle Shelf (C) & Bottom
Shelf (D) as shown, until fully seated into the groove on the inside of the Right Side Panel (A2).
Tip: If the Back Panels do not slide in easily, wiggle the panels while pushing into place.
Install Left Side Panel (A1) on to the Top Panel (B), Middle Shelf (C) & Bottom Shelf (D)
with six Hex Screws (F) using the Hex Tool.
Two Adults Recommended: Carefully rotate unit upright.
C
a
r
e
f
u
l
l
y
R
o
t
a
t
e
U
p
r
i
g
h
t
©2013 ECR4KIDS, LP Version: ELR-0450-A_EP_2015.03.26
Care and Cleaning
Clean wood with a damp cloth or sponge
using warm water and mild soap. Wipe dry.
Do not place near heat, moisture or
vaporizer which may cause wood to warp
and peel.
Check for loose or worn parts periodically
and tighten or replace as necessary.
Record the manufacture date here.
Information is located on the Batch ID
sticker and on the shipping carton.
Save this sheet in an accessible place.
Model Number: ELR-0450-A
Factory Code: EP
Manufacture Date:
Batch ID Number:
(Located on Part D)
We appreciate your purchase of the Two Shelf Storage Cabinet w/ Back.
ECR4KIDS has made every effort to supply a quality product that with proper
use and care, will provide many years of trouble-free use.
Warranty: Visit our website for product specific warranty information at:
www.ecr4kids.com
If you experience any difficulties with this product, please email us at
[email protected] or call toll-free at (855) ECR-4KIDS
(Monday - Friday, 7:00am - 4:00pm Pacific Standard Time)
Please do not return to place of purchase as ECR4KIDS will
replace defective part(s) and/or product.
To prevent a tip-over tragedy:
Buy and install low-cost anchoring devices that can prevent TVs,
dressers, bookcases and other furniture from tipping. For more
information please visit www.ecr4kids.com/resources