Edelbrock 9300 Owner's manual

Intake Manifold Gaskets & Cylinder Head Gasket Kits
INSTALLATION SUPPLEMENT
®
• We recommend the use of Edelbrock Gasgacinch (Part #9300) on the intake manifold mounting surface of the cylinder
head, and on the cylinder head side of the Intake Manifold Gaskets, in order to hold the gasket in place on the cylinder
head and to ensure a proper seal. Follow the instructions on the Gasgacinch can for the proper application procedure. DO
NOT USE Gasgacinch on cylinder head gaskets.
• Intake Manifold End seals are not included with Intake Manifold Gaskets. In applications that normally use intake manifold
end seals, use a 1/4” bead of RTV silicone in place of end seals (unless otherwise noted in the installation instructions for
the individual intake manifold being used). Make sure the bead overlaps the corners of the intake gaskets.
• Using a thin film of RTV silicone around any water jacket openings in the gasket (on the intake manifold side only) will help
ensure a proper seal around the water jacket openings.
Cyl. Head Gasket Kits & Intake Gaskets
Brochure No. 63-0287
©2004 Edelbrock Corp.
Rev. 8/04
Edelbrock Corporation
2700 California Street • Torrance, CA 90503
Tech Line: 1-800-416-8628
Tech E-Mail: [email protected]
Intake Manifold Gaskets & Cylinder Head Gasket Kits
INSTALLATION SUPPLEMENT
®
• We recommend the use of Edelbrock Gasgacinch (Part #9300) on the intake manifold mounting surface of the cylinder
head, and on the cylinder head side of the Intake Manifold Gaskets, in order to hold the gasket in place on the cylinder
head and to ensure a proper seal. Follow the instructions on the Gasgacinch can for the proper application procedure. DO
NOT USE Gasgacinch on cylinder head gaskets.
• Intake Manifold End seals are not included with Intake Manifold Gaskets. In applications that normally use intake manifold
end seals, use a 1/4” bead of RTV silicone in place of end seals (unless otherwise noted in the installation instructions for
the individual intake manifold being used). Make sure the bead overlaps the corners of the intake gaskets.
• Using a thin film of RTV silicone around any water jacket openings in the gasket (on the intake manifold side only) will help
ensure a proper seal around the water jacket openings.
Cyl. Head Gasket Kits & Intake Gaskets
Brochure No. 63-0287
©2004 Edelbrock Corp.
Rev. 8/04
Edelbrock Corporation
2700 California Street • Torrance, CA 90503
Tech Line: 1-800-416-8628
Tech E-Mail: [email protected]