Edimax EW-7303HPn V2 Instruction Manual

How to Establish WDS Connection Between Two EW-7303HPn v2
Topology
1. Connect EW-7303APn V2 - 1 and PoE injector using 4-pair cable.
2. Connect PC1 and PoE injector using cable.
3. Connect EW-7303APn V2 - 1 and PoE injector using 4-pair cable.
4. Connect PC2 and PoE injector using cable.
5. Please configured the IP address of PC1 and PC2 as below.
Configuration Steps
1. Open web browser on PC1, type 192.168.2.1 on the address bar, and press enter.
2. The default username/password is admin/1234.

3. Click Wireless Settings, click Basic, change Wireless Mode to WDS, click Apply, and then click Reboot
Now.
4. After reboot, please configure as the below.
a. Click Wireless Settings, and then click WDS
b. You could configured the encrypt type, or just leave it none.
c. Enter the MAC address of the EW-7303APn v2 -2. The MAC address is on the label stuck on the
EW-7303APn V2 –2.
d. Click Apply, and then click Reboot now.
5. Open web browser on PC2, type 192.168.2.1 on the address bar, and press enter.
6. The default username/password is admin/1234.

7. Click Wireless Settings, click Basic, change Wireless Mode to WDS, click Apply, and then click Reboot
Later.
8. Click Internet Settings, click LAN, change IP Address as 192.168.2.2, and then click Apply. It will reboot.

9. After reboot, please configure as the below.
a. Click Wireless Settings, and then click WDS
b. You could configured the encrypt type, or just leave it none.
c. Enter the MAC address of the EW-7303APn v2 -2. The MAC address is on the label stuck on the
EW-7303APn V2 –2.
d. Click Apply, and then click Reboot now.
10. Click Start on PC2 , type cmd and press enter referring to the below.

11. Type ping 192.168.2.10. If they are connected, it will show “Reply from ……”. The connection is
established successfully. If not, please help check whether the security or the MAC address is not
correct.