ekwb EK-Loop PCI Bracket Pass-Through User manual

USER GUIDE
EK-Loop
PCI Bracket Pass-Through

Please note the installation of the product is intended to be undertaken
by an adequately trained and experienced person. You are installing the
product at your own risk. If you are not properly trained or experienced
or feel unsure about the installation procedure, please refrain from
installing the product yourself and contact our tech support for
assistance. We disclaim our liability for any damages to the product as
well as incidental, consequential, or indirect damages incurred due to
improper or inappropriate installation.
Before you start using this product, please follow these basic guidelines:
Carefully read the manual before beginning with the
installation process.
The EK Fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured by the
rubber O-ring gaskets.
Using corrosion-inhibiting coolants is always recommended
for liquid cooling systems and mandatory for nickel-plated
water blocks!
Do not use pure distilled water!
For best results, EK recommends the use of EK-CryoFuel
coolants! To reach optimal performance, make sure to bleed
the air out of your water block thoroughly!

- 3 -
TABLE OF CONTENTS
TECHNICAL SPECIFICATIONS AND MAIN PARTS 4
INSTALLING THE EK-Loop PCI Bracket Pass-Through 4
SUPPORT AND SERVICE 6
SOCIAL MEDIA 6

- 4 -
TECHNICAL SPECIFICATIONS AND MAIN PARTS
Position EAN Description Quantity
1106837 Single slot bracket (Bl.) 1
2106834 Pass Trought nut (Ni) 2
3106832 Pass Through screw (Ni) 2
4106930 Rubber 5.5/8*1 NBR 1
55192 OR 7 x 1.5 mm 2
5
4
1
2
3
INSTALLING THE EK-Loop PCI Bracket Pass-Through
STEP 1
First, remove one (1) GPU expansion slot from the PC Chassis. Save
the removed screw for later steps.
STEP 1
PC CHASSIS
SCREW
GPU
EXPANSION
SLOT
Phillips Head Screwdriver
For this step, you will need:

- 5 -
STEP 2
Replace the original GPU Expansion slot with the EK-Loop PCI Bracket
Pass-Through. Secure the bracket with the saved PC Chassis screw.
Make sure to rotate the bracket as shown in the picture.
* The cable management hole, featuring a rubber gasket,
prevents friction damage to cables passing through the metal
gap on the bracket.
STEP 2
PC CHASSIS
SCREW
EK-LOOP PCI BRACKET
PASS-THROUGH
For this step, you will need:
PC Chassis screw
EK-Loop PCI Bracket
Pass-Through
Phillips Head
Screwdriver

In case you need assistance or wish to order spare parts or a new
mounting mechanism, please contact:
https://www.ekwb.com/customer-support/
For spare parts orders, refer to the page with “TECHNICAL
SPECIFICATIONS AND MAIN PARTS” where you can find the EAN
number of each part you might need.
Include the EAN number with quantity in your request.
EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
ekwaterblocks
EKWBofficial
SUPPORT AND SERVICE
SOCIAL MEDIA