eldoLED SOLOdrive 560/S Quick start guide

Pay attention when connecting the LED groups:
polarity reversal results in no light output and often damages the LEDs.
© 2012 eldoLED. All rights reserved. V1.0
More documentation and eldoLED’s terms and conditions are available at www.eldoled.com.
{
+
+
-
-
120-277 VAC
2
1
9 mm
0.35 inch
0.5-1.5 mm
2
AWG 20-16
DALI
L
N
+
-
LEDcode / NTC
2 LED groups
(1 ballast)
Wiring diagram SOLOdrive 560/S (SL0560S1)
WARNING: Risk of electrical shock. May result in serious injury or death. Disconnect power before servicing or installing.
CAUTION: The device may only be connected and installed by a qualified electrician. All applicable regulations, legislation and build-
ing codes must be observed. Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs.
LED group
Indicates the location of the connectors for your LED groups. These
LED groups represent one DALI ballast.
LED wiring distance
Maximum wiring distance at full load:
LEDcode/NTC
LEDcode allows configuration of
• Dimming curve: lin / log
• Minimum dimming level
• NTC throttle temperature
• LED drive current per output: from 200mA-1,050mA in 1mA steps
Programming the driver via LEDcode requires a TOOLbox pro and
FluxTool software.
Connecting a 47kΩNTC thermistor enables closed loop thermal
control. The NTC throttle temperature is programmable through
LEDcode.
DALI
You can use these connectors to connect the driver to a DALI network.
Always combine a DA+ and DA- connector for either data input or data
output.
120-277 VAC
The driver has been designed for use with universal mains voltage in-
put of 120-277 VAC, 50/60Hz.
AWG value 20 19 18 17 16
Distance(m)1418222836
Distance (ft) 45.9 59 72.2 91.9 118.1
Please observe voltage drop over long cable lengths.
Longer cable lengths increase EMI susceptibility.

eldoLED Europe bv Luchthavenweg 18a 5657 EB Eindhoven The Netherlands T [phone] F [phone] [email protected]
eldoLED America, Inc. 1762 Technology Drive # 226 San Jose, CA95110 USA T [phone] F [phone] [e-mail]
Wiring diagram SOLOdrive 560/S (SL0560S1)
Connecting 1 LED group
Group 1
Group 2
LEDcode
NTC
DA
DA
120-277VAC
50-60Hz