ElectrIQ HVF18C User manual

USER MANUAL
HVF18C
HVF18B
18 INCH HIGH VELOCITY FAN
Thank you for choosing ElectriQ
Please read this user manual before using this air circulator and keep it safe for future reference.
Visit our page www.electrIQ.co.uk for our entire range of Intelligent Electricals

2
CONTENTS
SAFETY INSTRUCTIONS
3
FEATURES AND ASSEMBLY
4
CONTROL PANEL AND SETTINGS
5
MAINTENANCE
6
TROUBLE SHOOTING
6 6
APPENDIX
7

3
SAFETY INSTRUCTIONS
Important!
•Carefully read the instructions before operating the unit
•This appliance is for indoor use only.
•Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.
•Installation must be in accordance with regulations of the country where the unit is used.
•If you are in any doubt about the suitability of your electrical supply have it checked and, if
necessary, modified by a qualified electrician.
•This fan has been tested and is safe to use. However, as with any electrical appliances - use
it with care.
•Disconnect power plug from socket before dismantling, assembling or cleaning the unit
•Avoid touching any moving parts of the appliance.
•Never insert fingers, pencils or any other objects though the guard
•This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities. It is also not intended for use by those with a lack of
experience and knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their safety.
Do not leave children unsupervised with this appliance.
•Do not clean the unit by spraying it or immersing it in water.
•Never connect the unit to an electrical outlet using an extension cord. If an outlet is not
available, one should be installed by a qualified electrician.
•Never operate this appliance if the cord or plug is damaged. Ensure the power cord is not
stretched or exposed to sharp object/edges.
•A damaged supply cord should be replaced by the manufacturer or a qualified electrician
in order to avoid a hazard.
•Any service other than regular cleaning should be performed by an authorized service
representative. Failure to comply could result in a voided warranty.
•Do not operate the fan unassembled without protective front and rear grilles in position.
•Do not use the appliance for any other purposes than its intended use.
•Never use the mains plug as a switch to start and turn off the fan. Use the provided
ON/OFF switch located on the control panel.
•Always place the unit on a dry and stable surface. Do not move or tilt the unit
•High Velocity fans are designed to create rapid air movement, therefore make sure the fan
is not placed near curtains or any objects that may be drawn into the fan inlet.
•The appliance should not be installed in laundry or wet rooms
•Do not use this unit in environments with flammable and explosive gases.
•Avoid keeping the unit in direct sunlight for a long period of time
Energy Saving and Unit Safety Protection Tips
•Do not cover or restrict the airflow. Do not use in dusty environment.
•For maximum performance the minimum distance from a wall or objects should be 50cm.
Warning: To reduce the risk of fire or electrical shock, DO NOT USE THIS FAN with any SOLID
STATE Speed Control Device or any variable speed controllers.

4
HVF18C / HVF18B 18-Inch High Velocity Cool Air Circulator Fan with 3 Speed
Settings
SPECIFICATIONS
⚫High air flow 5000 m3/ hr (3,600cfm)
⚫Slim design takes minimal space
⚫High Speed Motor with 3 Fan Speed Settings
⚫Adjustable Tilt Head
PARTS LIST
1. MAIN FAN BODY AND
GRILLS
2. MOUNTING SCREWS
3. FAN STAND
FAN ASSEMBLY
1. Assemble the fan stand legs into a frame as shown in the images below
2. Install the fan body into the frame and secure with the mounting screws
3. Adjust the fan angle and tighten the screws in place

5
OPERATION
1. Set your fan on a level dry surface.
2. Before plugging into the wall outlet adjust the fan head to your desired angle:
loosen the mounting screws then tighten them back in position.
3. Plug the power cord into a standard 220~240 V wall outlet.
CONTROL PANEL AND SETTINGS
Twist the control knob from the 0 and select
the appropriate speed Low (1) Medium (2)
High (3)
INSTALLATION
This unit can easily be moved from one room to another. While moving the unit please note
that it must always be kept upright and then placed on an even surface.
•Remove any packaging - keeping the fan in a vertical position.
•Make sure all parts are present and unit is assembled correctly
•Connect the power plug to a working socket, and then press the power button.

6
MAINTENANCE
CLEANING AND STORAGE
ATTENTION: Please shut off the unit and unplug from the mains before cleaning or
performing any maintenance.
Cleaning the surface
Clean the grills with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage. Make sure no water enters the control panel or fan motor
Do not run the unit until completely dry.
Place the fan in its original box or cover the fan to protect it from dust.
Store it in a cool dry place.
TROUBLESHOOTING
Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate
the warranty and may cause bodily harm.
Issue
Possible Reason
Solution
No power
1. Power cord is unconnected
2. The There is no power from socket
3. The power switch is not on.
4. The fuse has blown
1. Connect the power cord
2. Check socket is turned on
3. Turn the unit on
4. Replace the fuse in the plug
Odour emission
from unit
1. New unit. When the unit is used for
the first time the fan motor may
produce and odour which will
dissipate within a week of use
1. No action required
Strong vibrations
and noise
1. Fan is not used on a flat surface
2. Fan may be damaged
1. Place on a flat surface. May put an
anti-vibration matt underneath
2. if fan is damaged discontinue use
and contact service centre
If the above solutions do not resolve the problem please contact the service centre.

7
TECHNICAL DATA:
Model
HVF18C / HVF18B
High Velocity
Fan Speed
3
Blade size
450 mm
Cable length
1.5 meters
Rated Input
110 Watt
Running Current
0.5 Amps
Air Flow
5000 m3/hr (3600 CFM)
Noise
Max 57db
Power Supply
230V/50Hz
Net Weight
4.7 kg
Gross Weight
3.3 kg
Net Size (assembled)
550mm x 220mm x 560mm
Gross Size (packed)
510mm x 185mm x 510mm

8
electriQ UK SUPPORT
www.electriQ.co.uk/support
Call: 0330 390 3061 or complete the online form
Office hours: 9AM - 5PM Monday to Friday
www.electriQ.co.uk
Unit J6, Lowfields Business Park
Lowfields Way, Elland
West Yorkshire, HX5 9DA
Disposal: Do not dispose this product as unsorted municipal waste. Collection of such
waste must be handled separately as special treatment is necessary.
Recycling facilities are now available for all customers at which you can deposit your old
electrical products. Customers will be able to take any old electrical equipment to participating
civic amenity sites run by their local councils. Please remember that this equipment will be further
handled during the recycling process, so please be considerate when depositing your equipment. Please
contact the local council for details of your local household waste recycling centres.