ElectrIQ TF29OSCT8RW User manual

USER MANUAL
TF29OSCT8RW
29 INCH TOWER FAN
Thank you for choosing ElectriQ
Please read this user manual before using this air circulator and keep it safe for future reference.
Visit our page www.electrIQ.co.uk for our entire range of Intelligent Electricals

Page 2of 9
CONTENTS
SAFETY INSTRUCTIONS
3
FEATURES
4
DIAGRAM
4
INSTALLATION
5
OPERATION
5
CONTROL PANEL AND SETTINGS
5
REMOTE CONTROL
5
MAINTENANCE
7
TROUBLE SHOOTING
7 6
APPENDIX
8

Page 3of 9
SAFETY INSTRUCTIONS
Important!
Carefully read the instructions before operating the unit
This appliance is for indoor use only.
Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.
Installation must be in accordance with regulations of the country where the unit is used.
If you are in any doubt about the suitability of your electrical supply have it checked and, if
necessary, modified by a qualified electrician.
This fan has been tested and is safe to use. However, as with any electrical appliance - use it
with care.
Disconnect the power from the unit before dismantling, assembling or cleaning the unit
Avoid touching any moving parts of the appliance.
Never insert fingers, pencils or any other objects though the guard
This appliance can be used by Children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without supervision.
Do not clean the unit by spraying it or immersing it in water.
Never connect the unit to an electrical outlet using an extension cord. If an outlet is not
available, one should be installed by a qualified electrician.
Never operate this appliance if the cord or plug is damaged. Ensure the power cord is not
stretched or exposed to sharp object/edges.
A damaged supply cord should be replaced by the manufacturer or a qualified electrician in
order to avoid a hazard.
Any service other than regular cleaning should be performed by an authorized service
representative. Failure to comply could result in a voided warranty.
Do not use the appliance for any purpose other than for its intended use.
Never use the mains plug as a switch to start and turn off the fan. Use the provided ON/OFF
switch located on the control panel.
Always place the unit on a dry and stable surface. Do not move or tilt the unit
High Velocity fans are designed to create rapid air movement, therefore make sure the fan is
not placed near curtains or any objects that may be drawn into the fan inlet.
The appliance should not be installed in laundry or wet rooms
Do not use this unit in environments with flammable and explosive gases.
Avoid keeping the unit in direct sunlight for a long period of time
Energy Saving and Unit Safety Protection Tips
Do not cover or restrict the airflow. Do not use in dusty environment.
For maximum performance the minimum distance from a wall or objects should be 50cm.
Warning: To reduce the risk of fire or electrical shock, DO NOT USE THIS FAN with any SOLID
STATE Speed Control Device or any variable speed controllers.

Page 4of 9
TF29OSCT8RW 29 Inch Tower Fan with 3 Speed Settings
FEATURES
Slim design takes minimal space
High Speed Motor with 3 Fan Speed Settings
Swing Function
7.5 hour standby timer allows the operating time to be set in 30 minute intervals.
Remote Control allowing all functions to be changed.
Choice of modes allowing the operation of the unit to be adjusted to the
environment.
DIAGRAM

Page 5of 9
INSTALLATION
1. Push the two parts of the base together
ensuring that the power cable is fed
through the center.
2. Line up the tower fan on the base and fix
the 4 screws into position using a
screwdriver
3. Press the power cable into the two clips in
the underside of the base, so that it runs
out of the rear of the base.
OPERATION
Once assembled your fan may be operated by using either the manual controls located on the top of the
fan or by your remote control.
CONTROL PANEL AND SETTINGS
1
2
3
4
5
6
7
8

Page 6of 9
1. POWER BUTTON
Used to turn the tower fan ON and OFF.
2. SPEED BUTTON
Press to cycle through the three available fan speeds.
Lo –Low Speed, M –Medium Speed and Hi –High Speed
3. MODE BUTTON
Press to cycle through the modes.
Standard Mode: The fan will operate normally
Breeze Mode: The fan speed will vary to imitate a natural breeze.
Sleep Mode: The fan speed will be decrease by a level every 30 minutes, and once on low
will remain running at that speed.
4. TIMER BUTTON
Press repeatedly to increase the running time in 30 minute intervals. The timer can be set between
30 minutes and 7.5 hours.
5. SWING BUTTON
Press to turn the Swing function on and off. When it is operational the horizontal direction of the
airflow is slowly moved from side to side.
6. FAN SPEED INDICATOR
The corresponding light will illuminate to indicate the current fan speed. . I –Low Speed, II –
Medium Speed, and III –High Speed.
7. TIMER INDICATOR
When setting the timer add up the lights to determine the length of timer set. i.e. If the 1hr, 2hr,
and 4hr lights are illuminated the timer is set for 7 hours.
8. MODE INDICATOR
One light will illuminate to indicate the current mode which is operating.
REMOTE CONTROL
The Buttons on the remote have the same effect as the
buttons on the main control panel.
1
Power Button
2
Speed Button
3
Swing Button
4
Timer Button
5
Mode Button
The remote contains a button cell battery (CR2025)
1
2
3
4
5

Page 7of 9
MAINTENANCE
CLEANING AND STORAGE
ATTENTION: Please shut off the unit and unplug from the mains before cleaning or
performing any maintenance.
Cleaning the surface
Clean the grills with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage. Make sure no water enters the control panel or fan motor
Do not run the unit until completely dry.
Place the fan in its original box or cover the fan to protect it from dust.
Store it in a cool dry place.
TROUBLESHOOTING
Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate
the warranty and may cause bodily harm.
Issue
Possible Reason
Solution
No power
1. Power cord is unconnected
2. The There is no power from socket
3. The power switch is not on.
4. The fuse has blown
1. Connect the power cord
2. Check socket is turned on
3. Turn the unit on
4. Replace the fuse in the plug
Odour emission
from unit
1. New unit. When the unit is used for
the first time the fan motor may
produce and odour which will
dissipate within a week of use
1. No action required
Strong vibrations
and noise
1. Fan is not used on a flat surface
2. Fan may be damaged
1. Place on a flat surface. May put an
anti-vibration matt underneath
2. if fan is damaged discontinue use
and contact service centre
If the above solutions do not resolve the problem please contact the service centre.

Page 8of 9
APPENDIX
Disposal: Do not dispose this product as unsorted municipal waste. Collection of such
waste must be handled separately as special treatment is necessary.
Recycling facilities are now available for all customers at which you can deposit your old
electrical products. Customers will be able to take any old electrical equipment to participating
civic amenity sites run by their local councils. Please remember that this equipment will be
further handled during the recycling process, so please be considerate when depositing your
equipment. Please contact the local council for details of your local household waste recycling
centres.
TECHNICAL DATA
Model
TF29OSCT8RW
Fan Speeds
3
Cable length
1.5 meters
Rated Input
45 Watt
Running Current
0.2 Amps
Air Flow
19.45 m3/min
Noise
Max 53dB(A)
Power Supply
220-240V~50/60Hz
Net Weight
2.7 kg
Gross Weight
3.2 kg
Net Size (assembled)
270 x 272 x 745mm
Gross Size (packed)
760 x 200 x 187mm

Page 9of 9
ElectrIQ UK SUPPORT
www.ElectrIQ.co.uk/support
Please, for your own convenience, make these simple checks
before calling the service line.
If the unit still fails to operate call: 0871 620 1057 or complete
the online form
1. Is the unit plugged into the mains?
2. Is the fuse OK?
3. Switch the unit off and wait three minutes to see if the issue
is resolved. Restart the unit.
Office hours: 9AM - 5PM Monday to Friday
www.ElectrIQ.co.uk
Unit 2, The Nursery
Berristow Lane
South Normanton
Derbyshire, DE55 2FX