Elkay HRC2-10-1D User manual

98244C (3/06)
HRC2-10-1D
NOTE: It is important to insure proper ventilation. Allow a
minimum clearance of 6 inches (152 mm) in front and 3
inches (76mm) in the rear of the unit. If unit is to be in-
stalled in an enclosure, allow the following clearances
around unit 1 inch (25mm) each side, 3 inches (76mm) in
the rear, 3 inches (76mm) inches above wall.
This chiller has been designed for use with potable water
and includes an o-ring seal on the drain plug. This fitting
should be replaced if the unit is to be used with more
aggressive fluids.
Refrigeration Packages
Installation Instructions
A=3/8"O.D.TUBEWATEROUT
B=3/8"O.D.TUBE WATER INLET
C=3/8"O.D. TUBE TANKDRAIN
D= TEMPERATUREADJUSTMENT
E=ELECTRICAL
LEGEND:

98244C (3/06)
HRC2-10-1D
27666C
31513C
31490C
30664C
20282C
70018C
70009C
66305C
50189C
66203C
35774C
35818C
36222C
35795C
30180C
36221C
35806C
31797C
30181C
30182C
19037000
100806740570
66311C
27665C
70772C
28399C
27663C
28400C
27664C
27667C
35882C
27669C
27668C
ITEM
NO. 10 GPH
PART NO.
1
2
3
4
5
6
7
8
9
10
11*
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
NS
ITEMIZEDPARTS LIST
DESCRIPTION
Cover - Terminal Box
Control - Cold
Motor - Fan
Fan - Blade
Fan - Bracket
Fan - Nut
Screw - Motor Mounting
Condenser
Shroud
Drier
Compr. ServPakEmbraco
Compr. Serv Pak Tecumseh
Overload (Embraco)
Overload (Tecumseh)
Overload Spring (Tecumseh)
Relay (Embraco)
Relay (Tecumseh)
Cover - Relay (Embraco)
Cover - Term (Tecumseh)
Compr. Bale Strap (Tecumseh)
Clip
Grommet
Evaporator - Assy
Cover - Insulation Box
DrainPlug
Base Assy
Panel - Insul Box (Rear)
Panel-End
Box - Insulation (Front)
Terminal Box Assy
Control-Freeze Protect
Grille - Front
Grille - Rear (Not Shown)
8,9 25 21
24
18
3, 4, 5, 6, 7
10
12,13,14
22
26
20
11
15,16
19
17
23
21
*INCLUDESRELAY& OVERLOAD. IFUNDER WARRANTY,
REPLACE WITH SAME COMPRESSOR USED IN ORIGINAL
ASSEMBLY.
NOTE: All correspondence pertaining to any of the
above water cooler or orders for repair MUST include
model number and serial number of cooler, name and
part number of replacement part.
NOTE: For use with photo processing applications,
adjust thermostat to warmer settings.