Elkay LL671-14*1D Installation manual

97350C (Rev. B - 11/02)
LL671-14*1D, 2D
PAGE 1
With FLEXI-GUARD®
Installation/Care/Use Manual
USES HFC-134A REFRIGERANT
FIG. 1
SEE FIG. 4 7
28
14
SEE FIG. 3
26
27 & 30
22, 23,
24, & 25
17, 18,
19, & 20
13
29
15 & 16
21
31 & 32

97350C (Rev. B - 11/02)
LL671-14*1D, 2D
PAGE 2
FIG. 2
E = INSURE PROPER VENTILATION BY MAINTAINING 4" (102mm) (MIN.) CLEARANCE FROM CABINET LOUVERS TO WALL.
ASEGURE UNA VENTILACIÓN ADECUADA MANTENIENDO UN ESPACIO E 4" (102mm) (MÍN.) DE HOLGURA ENTRE LA REJILLA DE VENTILACIÓN DEL MUEBLE Y LA PARED ASSUREZ-VOUS UNE BONNE VENTILATION EN GARDANT 4" (102mm) (MIN.) ENTRE LES ÉVENTS DE LENCEINTE ET LE MUR.
F = POWER CORD 4 FEET (1219mm) LONG
CABLE ELÉCTRICO DE 4 PIE (1219mm), DE LARGO CORDON DALIMENTATION 4' (1219mm)
G = ALT. ELECTRICAL OUTLET LOCATION
UBICACIÓN ALT. DE LA TOMA DE ELECTRICIDAD EMPLACEMENT ALTERNATIF DE LA PRISE DE COURANT
FINISHED FLOOR PISO ACABADO PLANCHER FINI
LEGEND/LEYENDA/LÉGENDE A = RECOMMENDED WATER SUPPLY LOCATION 3/8 O.D. UNPLATED COPPER TUBE CONNECT STUB OUT 1-1/2 IN. (38mm)
FROM WALL SHUT OFF BY OTHERS
SE RECOMIENDA UBICAR ELTUBO CORTO DE CONEXIÓN ALTUBO DE COBRE SIN CHAPAR DE 3/8" DE DIÁM. EXT.A 1-1/2"
(38 mm) FUERA DE LA LLAVE DE PASO EN LA PARED COLOCADA POR TERCEROS.
EMPLACEMENT RECOMMANDÉ D'ALIMENTATION EN EAU PAR TUBE EN CUIVRE NON PLAQUÉ DE 3/8 PO. (9,5 mm) D.E.
CONNECTANT UNE TUYAUTERIE DE 1-1/2 PO. (38 mm) DEPUIS LE ROBINET D'ARRÊT FOURNI PAR D'AUTRES.
B = RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/4 O.D. DRAIN
UBICACIÓN RECOMENDADAPARAEL DRENAJE DE SALIDADE AGUA, DE 1¼ DE DIÁMETRO. EMPLACEMENT RECOMMANDÉ POUR LE DRAIN DE D.E. 1-1/4" DE SORTIE DEAU.
C = 1-1/4 TRAP NOT FURNISHED
PURGADOR DE 1¼ NO PROPORCIONADO SIPHON 1-1/4 NON FOURNI
D = ELECTRICAL OUTLET LOCATION
UBICACIÓN DE LA TOMA DE ELECTRICIDAD EMPLACEMENT DE LA PRISE DE COURANT

97350C (Rev. B - 11/02)
LL671-14*1D, 2D
PAGE 3
FIG. 3
FIG. 4
NOTE:
WHEN INSTALLING REPLACEMENT
BUBBLER AND PEDESTAL, TIGHTEN
NUT (ITEM 12) ONLY TO HOLD PARTS
SNUG IN POSITION.
DO NOT OVER TIGHTEN.
BASIN
9
10
11
12
8
Stream height is factory set at 35 PSI. If supply pressure varies
greatly from this, remove Items 1 & 2 and adjust screw on
Item 4. Clockwise adjustment will raise stream and counter-clockwise
adjustment will lower stream. For best adjustment, stream should hit
basin approximately 6-1/2" (165mm) from bubbler.
BASIN
4
3
1
5
6
2

97350C (Rev. B - 11/02)
LL671-14*1D, 2D
PAGE 4
PRINTED IN U.S.A.
PARTS LIST 115V
ITEM NO. PART NO. DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22*
23
24
25
26
27
28
29
30
31
32
RIGHT
PANEL
FRONT
PANEL
LEFT
PANEL
COLOR
TABLE
Gray Beige
Almond
Stainless Steel
Sandalwood
Granite
Light Gray
21073C
21473C
21081C
21471C
27162C
28388C
21072C
21472C
21080C
21470C
27159C
28387C
20675C
20676C
20672C
21454C
27150C
21455C
*INCLUDES RELAY & OVERLOAD. IF UNDER WARRANTY, REPLACE
WITH SAME COMPRESSOR USED IN ORIGINAL ASSEMBLY.
NOTE: All correspondence pertaining to any of the above water coolers
or orders for repair parts MUST include Model No. and Serial No. of cooler,
name and part number of replacement part.
31440C
31430C
35764C
31028C
35768C
14
17
22*
23
24
Power Cord
Fan Motor
Compressor Serv. Pak
Overload/Relay Assy
Relay Cover
PART. NO. DESCRIPTIONITEM NO.
220/240v 50/60 Hz
Cover
Button
Regulator Retaining Nut
Regulator
Hex Nut
Regulator Holder
Basin
Bubbler Assy
Orifice Assy
Housing Assy
Pedestal
Bubbler Locknut
Cold Control
Power Cord
Condenser
Fan Shroud
Fan Motor
Fan Blade
Fan Bracket
Fan Blade Nut
Drier
Compressor Serv. Pak
Overload/Relay Assy
Relay Cover
Electrical Shield
Strainer
Precooler
Heat Exchanger
Evaporator
Receptor-Drain
Base
Angle
40089C
40048C
15005C
61313C
40169C
50986C
20776C
56073C
40322C
56011C
55997C
75580C
31513C
31502C
61013C
21516C
31490C
30664C
20239C
70018C
66202C
35762C
31027C
35766C
194243901550
55996C
45693C
66229C
66505C
50368C
27247C
27248C
www.DrinkingFountainDoctor.com 800-518-5388