Page 3 1000002232 (Rev. D - 01/19)
VRCTL8*2CQ, LVRCTL8*2CQ
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN
AUTHORIZED SERVICE PERSON
HANGER BRACKETS & TRAP
INSTALLATION
1) Remove hanger bracket fastened to back of
cooler by removing one (1) screw.
2) Mount the hanger bracket and trap as shown
in Figure 2.
NOTE: Hanger Bracket MUST be supported
securely. Add xture support carrier if wall will
not provide adequate support.
IMPORTANT:
• 4 3/4 in. (121mm) dimension from wall to
centerline of trap must be maintained for proper
t.
• Anchor hanger securely to wall using all ve
(5) 1/4 in. dia. mounting holes.
3) Install straight valve for 3/8” O.D. tube.
INSTALLATION OF COOLER
4) Hang the cooler on the hanger bracket. Be
certain the hanger bracket is engaged properly
in the slots on the cooler back as shown in Figure
2.
5) Loosen the two (2) screws holding the lower
front panel at the bottom of cooler base and
two (2) screws at the top (Use torx bits sold
separately). Remove the front panel and set
aside.
6) Connect water inlet line--See Note 4 of General
Instructions.
7) Remove the slip nut and gasket from the trap
and install them on the cooler waste line mak-
ing sure that the end of the waste line ts into
the trap. Assemble the slip nut and gasket to
the trap and tighten securely. Recommend
fastening cooler to wall using 7/16 bolt holes.
(See Fig. 2 “F”)
START UP
Also See General Instructions
8) Stream height is factory set at 45-50 PSI. If
supply pressure varies greatly from this, adjust
screw using the access hole in the pushbutton
(insert screwdriver). CW adjustment will raise
stream and CCW adjustment will lower stream.
For best adjustment, stream should hit basin
approximately 6-1/2” (165mm) from bubbler.
Fig. 3
VANDAL RESISTANT BUBBLER DETAIL
DETALLE DEL GRIFO RESISTENTE AL VANDALISMO
DESCRIPTION DU BARBOTEUR RESISTANT AU VANDALISME
ITEM
NO.
Filter Assy-1,500 Gal.
Kit-Filter Head Fittings, includes
John Guest 3/8” elbow tting
Assy-Filter & Bracket includes
Fltr Head/Mtg Bkt/John Guest
Fittings/Screws
1
2
3
51299C
98926C
0000000746
DESCRIPTION
PART
NO.
FILTER PARTS LIST
(See Fig. 4)
Fig. 4
3
1
2 2
BASIN
1
