emerio PAC-125336.2 User manual

- 1 -
Content –Inhalt –Teneur –Inhoud –Treść
Instruction manual –English......................................................................................- 2 -
Bedienungsanleitung –German...............................................................................- 20 -
Mode d'emploi –French ..........................................................................................- 38 -
Gebruiksaanwijzing –Dutch.....................................................................................- 56 -
Instrukcja obsługi – Polish ........................................................................................- 74 -

- 2 -
Instruction manual –English
Thank you very much for purchasing our products. In order
to ensure correct operation, please read this manual and
instruction carefully before use.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock,
burns and other injuries.
1. Read and save these instructions. Attention: pictures in
the IM are for reference only.
2. This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction
concerning use of the appliance in a safe way and
understand the hazards involved.
3. Children shall not play with the appliance.
4. Cleaning and user maintenance shall not be made by
children without supervision.
5. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
6. Indoor use only.
7. Do not use the unit in an area: near to source of fire;
where oil is likely to splash; exposed to direct sunlight;
where water is likely to splash; near a bath, a laundry, a
shower or a swimming pool.
8. Never insert your fingers, rods into the air outlet. Take
special care to warn children of these dangers.
9. Keep the unit upward while transport and storage, for the
compressor locates properly.
10. Before cleaning or moving the appliance, always turn off
and disconnect the power supply.
11. To avoid the possibility of fire disaster, the appliance shall

- 3 -
not be covered.
12. All the air-conditioner sockets must comply with the local
electric safety requirements. If necessary, please check it
for the requirements.
13. The appliance shall be installed in accordance with
national wiring regulations.
14. Details of type and rating of fuses：T, 250V AC, 3.15A.
15. Contact authorized service technician for repair or
maintenance of this unit.
16. Do not pull, deform or modify the power supply cord, or
immerse it in water. Pulling or misuse of the power
supply cord can result in damage to the unit and cause
electrical shock.
17. Compliance with national gas regulations shall be
observed.
18. Servicing shall only be performed as recommended by
the equipment manufacturer. Maintenance and repair
requiring the assistance of other skilled personnel shall
be carried out under the supervision of the person
competent in the use of flammable refrigerants.
19. Do not operate or stop the unit by inserting or pulling out
power plug, it may cause electric shock or fire due to
heat generation.
20. Unplug the unit if strange sounds, smell, or smoke comes
from it.
21. Always plug the appliance into an earthed plug socket.
22. In case of any damage, please turn off the switch,
disconnect the power supply, and contact an authorized
service center for repair.
23. Do not use means to accelerate the defrosting process or
to clean, other than those recommended by the
manufacturer.
24. The appliance shall be stored in a room without
continuously operating ignition sources (for example:
open flames, an operating gas appliance or an operating
electric heater.)

- 4 -
25. Do not pierce or burn.
26. Be aware that refrigerants may not contain an odour.
27. This appliance contains R290 refrigerant gas. R290 is a
refrigerant gas that complies with the European
directives on the environment. Do not puncture any part
of the refrigerant circuit.
28. If the appliance is installed, operated or stored in an
unventilated area, the room must be designed to prevent
to the accumulation of refrigerant leaks resulting in a risk
of fire or explosion due to ignition of the refrigerant
caused by electric heaters, stoves, or other sources of
ignition.
29. The appliance must be stored in such a way as to prevent
mechanical failure.
30. Individuals who operate or work on the refrigerant circuit
must have the appropriate certification issued by an
accredited organization that ensures competence in
handling refrigerants according to a specific evaluation
recognized by associations in the industry.
31. Repairs must be performed based on the
recommendation from the manufacturing company.
Maintenance and repairs that require the assistance of
other qualified personnel must be performed under the
supervision of an individual specified in the use of
flammable refrigerants.
32. Regarding the instructions for repairing appliances
containing R290, please kindly refer to below paragraphs.
33. Always let the appliance rest for at least 2 hours after
moving it from one location to another.

- 5 -
Warning: Risk of fire / Flammable materials.
Read instruction manuals.
Operator’s manual; operating instructions.
Service indicator; read technical manual.
Warning: Keep ventilation openings clear of obstruction.
Warning: The appliance shall be stored in a well-ventilated
area where the room size corresponds to the room area as
specified for operation.
The required distance around the unit should be at least
30cm.
Appliance shall be installed, operated and stored in a room
with a floor area larger than 10.1 m2.

- 6 -
PAC-125336.2 EN
PARTS DESCRIPTION
1. Control panel
2. Air outlet (with cover)
3. Room temperature display / Signal receptor
4. Remote control
5. Handle
6. Air exhaust outlet
7. Air inlet
8. Drain port (inserted by a stopper)
9. Window adaptor
10. Air exhaust hose
11. Cord rewinder
12. Air filter
Remote control
This unit has a remote control. One piece of CR2025 battery will be provided with the remote control. Before
starting to use the remote control, remove the plastic protection from the battery. If you want to change the
battery, please refer to the instruction behind the remote control. If it is not in use for a long time, please take
the battery out of the remote control. Keep button cell batteries out of reach of small children.
The functions of the buttons on the remote control are the same as the functions of the buttons on the
control panel.
Control panel

- 7 -
1. Power button
2. Temperature/timer increasing button
3. Temperature/timer decreasing button
4. Mode button
5. Fan speed button
6. Timer button
7. Sleep button
8. Swing button
9. Auto mode indicator light
10. Cooling mode indicator light
11. Drying mode indicator light
12. Fan mode indicator light
13. Low speed indicator light
14. Medium speed indicator light
15. High speed indicator light
16. Power indicator light
17. Auto-ON indicator light
18. Auto-OFF indicator light
19. Sleep indicator light
20. Digital display
21. Water-full indicator light
22. Swing indicator light
INSTALLATION
The unit shall be installed on a flat surface where the air outlet would not be blocked. The required
distance around the unit should be at least 30cm.
The unit shall not be installed in a laundry room.
Extend the air exhaust hose by drawingout the two ends of the hose.
Screw the air exhaust hose into the window adaptor.
Screw the other end of the exhaust hose onto the air exhaust outlet at the back of the unit.

- 8 -
OPERATION
*Always let the appliance rest for at least 2 hours after moving it from one location to another.
Before use, check up whether the exhaust hose has been mounted properly. Plug in the appliance.
1. Power button
Press the power button to turn on the appliance. The room temperature will be shown on the display.
The appliance will start to work. The power indicator light turns on when the appliance is on.
Press the button again, the appliance will be turned off.
2. Temperature/timer increasing button & temperature/timer decreasing button
Press the button “ ”/“ ” to set your desired room temperature from 15℃to 31℃. The buttons can
also be used for timer adjustment during timer setting. The value will be increased/decreased by 1 (℃
/hour) for each press.
3. Fan speed button
Press the fan speed button to switch the fan speed among low, medium and high speed. The
corresponding indicator light “LOW”/”MID”/”HIGH” will illuminate.
4. Mode button
Press the mode button to choose your desired working mode among AUTO, cooling, drying and fan mode.
The corresponding indicator light will turn on when the specific mode is selected.
•Auto mode
In AUTO mode, the indoor temperature sensor operates automatically to select the desired operation with
cooling or fan: when the room temperature is no less than 24 ℃，the unit automatically selects cooling
mode, and when the room temperature is less than 24 ℃， the unit automatically selects fan mode.
•Drying mode
The fan runs at a low speed. The fan speed and temperature cannot be adjusted.
The compressor will stop after 8 minutes of running and then run again after 6 minutes.
•Cooling mode
When the room temperature is higher than the set temperature, the compressor starts to run.
When the room temperature is lower than the set temperature, the compressor stops and the fan
operates at the original set speed.
Note: When the compressor is working, the unit will vibrate slightly. This is normal and harmless.
•Fan mode
When the fan runs at the set speed, the compressor does not run.
The adjustment of temperature in Fan mode is not effective.

- 9 -
5. Timer button
Auto-ON setting
-When the appliance is OFF, press the timer button, the auto-ON indicator light will flash.
-Press the timer increasing or decreasing button to select a desired auto-ON time from 1 to 24 hours.
The digital display and auto-ON indicator light will flash for several seconds, then the timer setting is
confirmed and the auto-ON indicator light will illuminate still.
-The appliance will automatically turn on once the select time passed.
Auto-OFF setting
-When the appliance is ON, press the timer button, the auto-OFF indicator light will flash.
-Press the timer increasing or decreasing button to select a desired auto-OFF time from 1 to 24 hours.
The digital display and auto-OFF indicator light will flash for several seconds, then the timer setting is
confirmed and the auto-OFF indicator light will illuminate still.
-The appliance will automatically turn off once the select time has passed.
To cancel the timer, set the time to 0 hour, or press into the timer setting, and when the digital display flashes,
press the timer button again. The auto-ON or auto-OFF indicator light will then turn off.
6. Sleep button (only active in cooling mode)
Press the sleep button to activate the sleep mode. The sleep indicator light turns on.
In sleep mode, the fan turns to low speed automatically. The set temperature will increase 1 ℃after
one hour, and increase 2 ℃after two hours. After six hours, the appliance stops running automatically.
7. Swing button
Press the swing button to activate the swing function, and the cover above the air outlet will swing slowly.
To stop the swing, just press the button again.
NOTE:
The protective device may trip and stop the appliance in the conditions listed below.
Cooling
Room temperature is over 43℃.
Room temperature is below 15℃.
Drying
Room temperature is below 15℃.
If the appliance runs in cooling or drying mode with door or window opened for a long time when
relative humidity is above 80%, dew may drip down from the air outlet.
To Shift the temperature unit between Celsius and Fahrenheit, long press both the temperature/timer
increasing and decreasing buttons (“ ”&“ ”) simultaneously when the appliance is on.
Drain water
1) Special reminder: There is condensing water recycling hidden in this appliance. The condensing water is
partly kept recycling between the condenser and the water tray. When the water level rises to the upper
level, the water-full code “E4” will be shown on the digital display to remind of draining water. The
water-full indicator light will also turn on.
2) Please cut off the power supply, move the appliance to a suitable place, pull out the stopper in the drain
port to drain the water completely. If conditions permitted, you can also connect the drain hose to the
drain port for the water draining.
3) After the draining, insert back the stopper to the drain port, otherwise the appliance may leak and make
your room wet.