enabot ebo SE User manual

SE

Download the Ebo App by scanning the QR code

Device Connection
0 1
1 2 3
Place the robot on the charging dock，connecting
when indicator lights are on（see the figure）．
Register on Ebo App and
click ‘+’ to connect.
Select device card for
Ebo SE.
Place the robot on the
charging dock.
* Updates are ongoing and subject to the actual interface of the App

0 2
45 6
Scan the QR code with Ebo’s camera until and are off,
and the pairing is successful.
About 15cm apart
Select wi Network;
Put in password;
Click NEXT
Scan the QR code with
the robot camera.
Successfully Connected!
English

Interface Instructions
0 3
Battery
Shoot
Video
Run
Forward
Rotating Shaking
Exit
Mic.
Operation
Setting
* Updates are ongoing and subject to the actual interface of the App
Volumn
On/Off
Take
Photo
Forward/Backward/
Left/Right
Left/Right
Forward/
Backward

General instructions
0 4
Indicator light
Mic.
Camera
Power
socket
Adapter USB
connector
Red light：Charging
Green light：Full
Charging
contact point
Indicator light
Reset button
Empty space
Detachable
Screw
SD card
Card slot
Speaker
*Larger-end of the pin
How to clean the wheels?
Dismount the screws at the botton with the
Larger-end of the pin to disassemble the
wheel set for cleaning.
*Smaller-end of the pin
Power on/o and RESET of Ebo:
Use the Smaller-end of the pin to press
RESET
POWER ON: Press RESET for 2 seconds
(or place the robot on the charging dock)
POWER OFF: Click RESET twice
REBOOT: Click RESET 1 time when Ebo is on
RESET: Press RESET for 5 seconds until you
hear ‘ebo’
＞0.6m ＞0.6m
＞2m
Note for charging Ebo:
Place the back side of the charging dock
along the wall and free from any obstacles
0.6 meters on right/left and 2 meters in front.
English