Enclume QR3 User manual

QR3-QUILT RACK
Enclosed you will find everything needed for the assembly
and use of your storage rack. Two people make assembly
and installation easier. The parts and hardware included are:
Hardware included:
4 – 5/16” x 3/4” Button Head Screws
2 – 5/16” x 1” Button Head Screws
6 – 5/16” Acorn Nuts
1 – 3/16” Allen Wrench
Components included:
2 – Upright Legs
2 – Straight Supports
1 – Curved Support
See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS
Thank you for choosing Enclume!
Enclume racks are the ultimate quality, design,
strength and function.
WARNING: READ ALL OF THE
INSTRUCTIONS BEFORE ASSEMBLING
AND USING YOUR RACK
If you need help, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Phone [phone] Fax [phone]
www.enclume.com
1” BUTTONHEAD SCREW

ASSEMBLY AND INSTALLATION INSTRUCTIONS
Rack Assembly
1) Lay the upright legs on the floor. Insert the curved support between the scroll section of the upright legs. Secure with a 1” button
head screw by inserting the screw through the hole on the scroll section of the upright leg and curved support and into the
threaded hole on the other side of the upright leg.
2) Repeat for the other upright leg. Snug the 1” button head screws, but do not tighten all the way..
3) Lift the rack into the upright position.
4) Align the straight support bar over the threaded hole in the scroll of the upright leg. Secure using the ½” button head screw by
inserting the screw through the hole in the straight support bar and into the threaded hole in the scroll of the upright leg. Repeat
the process for the other side of the straight support bar.
5) Repeat step 4 for the other straight bar.
6) Square up your quilt rack and tighten all button head screws with the hex key provided.
7) Your quilt racks is now fully assembled and ready to display your favorite quilt or blanket.
It is important that your rack is assembled correctly. If the unit is assembled or used
incorrectly, it could become unstable and collapse, possibly causing injury.
WARNING
Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall
be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the
warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20
days following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being provided to the customer by
Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING
OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.
¾
”
BUTTONHEAD
SCREW