Endon Daley User manual

69052-Daley-FL 20160815
Endon Lighting, LS9 0SE
Daley Floor Light
Safety Warnings
INSTRUCTION MANUAL
• This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE wiring
regulations. It is for indoor use only, and not suitable for a bathroom location.
• ThisttingisaClassII,DoubleInsulatedproduct and does not require an Earth. Live or Neutral must
not be connected to Earth.
• Do not plug into the mains until your lamp is fully assembled.
• Under no circumstances must this table lamp be covered with any material as this could pose a safety
hazard.Itmustbeusedonastable,atsurface.
• This product is not suitable for persons under 14 years of age.
• Nevertbulbsofahigherwattagethanthosespeciedonthelabelasthesemaycauseoverheatingand
damagethetting.
• The lamp must be protected by a 3 amp fuse in the mains plug.
• Ifthemainscablebecomesdamageditmustonlybereplacedbyatechnicallycompetent,qualiedperson.
• Ifyouareinanydoubtaboutyourcompetencepleaseconsultaqualiedelectrician.
• Ifanymodicationismadeitwillinvalidatethewarrantyandmayrendertheproductunsafe.
Assembly/ User Instructions
Before you start
Pleasereadtheseinstructionscarefullybeforettingandretainforreference.Checkthepackagingandmake
sure that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
These assembly diagrams are intended as a guide – if in doubt consult a qualied electrician.
Care Information
Allow 10 minutes to cool before replacing, adjusting or cleaning.
Cleanwithadryclothonly.Donotuseliquidorabrasivecleanersonthisproduct.
1. Carefullyunpackyourlamp,andplaceonastable,atsurface.Refertodiagramoverleaf.
2. Slot the sections of the stem together (1 & 3) ensuring the cable does not become trapped, and secure in
placeusingtheAllenkeyandscrews(2&4).Gentlypulloutanyexcesscable.
3. Fit the base by laying the lamp on it’s side. Fit the pan (5) over the base weight (6).
4. Secureinplaceusingthewashersandnuts(7&8).Fixthebasepad(9).
5. Slot the candle drip (10) over the lampholder, then secure the shade (11) with the shade ring (12).
6. InstalltheBulb(13).Donotinstallabulbwithagreaterwattageordifferentshapethanspeciedonthelabel.
7. Plug in, and operate the switch to turn your lamp on.
If your lamp will not illuminate, please check the bulb, the 3 amp fuse in the plug and ultimately check the
relevantfuseinyourfusebox.Ifunsuccessfulpleaseconsultyourretailer.
ClassIIPlugWiringDiagram

69052-Daley-FL 20160815
Endon Lighting, LS9 0SE
Assembly/ User Instructions