English Blinds Venetian Blinds User manual

Installation Guide for Venetian Blinds
1
2
Fitting the Brackets
The brackets can be fitted in two dierent ways:
Face Fix Top Fix
When positioning the brackets inside the window recess, make sure to allow for any obstructions such as window handles.
Installing the Blind
Locate the front lip
of the headrail into
the front of the bracket.
Push the front of the headrail
inwards and the back of the
headrail in an upwards direction
until it locks into the back of the
bracket.
3 cm
3 cm 3 cm
Ensure the outermost brackets are situated
3cm from the ends of the headrail.
Any additional brackets should be distributed
evenly across the width of the blind, ensuring
they do not obstruct any moving parts inside
the headrail.

Installation Guide for Venetian Blinds
3Child Safety
Drop of Blind *Distance between
cord cleats
(centre to centre)
1 - 1000mm
1001 - 2000mm
2001 - 3000mm
100mm
150mm
300mm
Breakaway Safety Tassel
A breakaway safety tassel comes pre-fitted
to the li cords, so when a horizontal force is
applied to the cords entering the tassel, it
will safely break apart thereby eliminating any
hazardous loops.
If the safety tassel becomes separated:
Firstly, untwist and untangle the cords.
If the blind features 2 cords: press
the tassel together until it is fully
closed.
If the blind features 3 cords: Place the
loose cord into the opening in one half
of the tassel and press the tassel
together until it is fully closed.
If you have any doubts that the tassel
has not been re-attached correctly, you
can test it by placing your arm between
the cords and pressing downwards. The
tassel should break apart with minimal
force.
Cord Safety Cleat
The safety cleat needs to be installed as close as possible to the headrail and in all cases not less than 1500mm from the floor. The
cords must be fully wrapped around the safety cleat(s) when the blind is not in use. Refer to the table below to determine the
distance required between the cleats to fully accumulate the cords when the blind is completely raised up.
*Distance between
cord cleats
(centre to centre)
Place the safety cleat in the
desired position on the wall
and mark the positions of
the holes with a pencil.
With the hole positions marked,
drill as required and use the
screws provided to attach the
safety cleat to the wall.
Wrap the cords around the
cord cleats in a figure of 8.
When the cords are fully
accumulated, ensure they
are secure so that when any
cord is pulled, no excess
cord is released.