ennoLogic eL200K User manual

ENNOLOGIC LIGHT METER EL200K-QUICK-START GUIDE 1
Install the Batteries
Use a screwdriver to unscrew the battery compartment
cover on the back of the unit and insert the four AA
batteries included in the package. Make sure the
polarity is correct (match the positive and negative
terminals according to the diagram inside
the battery compartment.)
Reinstall the battery cover.
Open the Package
When you open the package, you should
nd your manual, your light meter, its
carrying case, an analog output interface
cable, and 4x AA batteries. The manual is
located inside the lid, behind the foam.
1
2
EnnoLogic Light Meter eL200K
Quick-Start Guide
WHEN YOUR LIGHT METER ARRIVES

ENNOLOGIC LIGHT METER EL200K-QUICK-START GUIDE 2
Turning the Light Meter On and Off
Press the POWER key to turn the meter on.
Press it again to turn it o.
After 5 minutes without use the meter will
automatically power o.
Switching Units
Press the UNITS key to switch between Fc
(foot candle) and Lux.
Backlight
Press the BACKLIGHT key to turn
the backlight on or o.
Tracking the Maximum,
Minimum and Average Values
Press the MAX key to capture the maximum light
intensity. The reading will remain unchanged until
a higher reading is detected. Press the MAX key
again to capture the minimum reading (MIN), and
press it again to display average readings (AVG).
Press the MAX key one more time to exit this
mode.
TAKE IT FOR A SPIN

WANT TO LEARN MORE?
You’ll nd more information in the
user manual downloadable at our website.
QUESTIONS? NEED ADDITIONAL SUPPORT?
[email protected]
[phone]
ENNOLOGIC LIGHT METER EL200K-QUICK-START GUIDE 3
Hold Function
Press the HOLD key to enter and exit data hold
mode. When in Hold mode, the displayed value will
no longer update.
Disable Auto-Power-Off
To disable the Auto-Power-O feature hold the
UNITS key down while turning the meter on, then
release the UNITS key. You will see the Power symbol
appear on the LCD, indicating that the auto-power-o
feature has been disabled.
ADVANCED FEATURES
External Power
The unit can be powered with the USB cable provided, connected to
a standard USB power adapter or port.