Epson EP1314C3B User manual

EP1314C3B
REFILL INSTRUCTIONS
For Epson® T013201 & T014201
Contents:
Your kit should contain the following:
4 - 2oz bottle of ink, 1 30cc ink injector, 1 polly
wipe, 8 yellow seals, needle, drill tool, instructions.
If any of these items are missing please call us for a
replacement item or kit.
BLACK CARTRIDGE (T013201)
Place the cartridge to be filled on a paper towel in
case of spillage. Using the yellowseals cover the
exit hole to avoid leakage. Using the hand held drill
bit, drill a hole through one of the fill holes as
shown in Figure #1. Drill until you feel the drill bit
go all the waythrough. Attach the needle to the
syringe and draw25cc of black ink into it. Insert the
needle into the hole you predrilled and slowlyinject
the ink and at the same time lift up slightlyto expose
the ink to different parts of the internal sponge
inside the cartridge. Go to last step.
FIGURE 1
COLOR CARTRIDGE (T014201)
Place the cartridge to be filled on a paper towel in
case of spillage. Using the yellowseals cover the
exit holes on each color to avoid leakage. Using the
hand held drill bit, drill a hole through one of the fill
holes as shown in Figure #2. Drill until you feel the
drill bit go all the waythrough. Wash the bit with
water between each newhole drilled. Attach the
needle to the syringe and draw16cc of the proper
color ink into it. Insert the needle into the hole you
predrilled and slowlyinject the ink and at the same
time lift up slightlyto expose the ink to different
parts of the internal sponge inside the cartridge.The
cartridge mayor maynot take all of the ink,
depending on howemptyeach color was. Wash the
injector between colors to prevent contamination.
FIGURE 2
LAST STEP FOR BLACK AND COLOR CARTRIDGES
Care should be used in filling these cartridges since the print head is internal and made to be permanent,
which makes it susceptible to small particles clogging it over time. Both have an internal sponge for ink
retention. If the cartridge is to be used soon after refilling do not cover the FILL holes with tape as these are
vents and need to be open in order for the cartridge to work. The exit holes need to be resealed to prevent
leaking. Use the yellowround sealing dots to cover the ink exit holes to avoid leaking when refilling.
Remove the seals before installing the cartridge back into your printer. For long termstorage, cover the top
openings with tape to prevent the cartridge fromdrying out.
TROUBLE SHOOTING
PRINTS IN STREAKS / MISSING LINES : Performprint head clean procedure as described in the
owners manual.
CARTRIDGE LEAKS: Cartridge is not sealed properly. Reseal cartridge. The cartridge is overfilled.
Place on a paper towel until it stops leaking.
ATLASCOPY.COM
P.O. Box 1185
Milford, DE. 19963
http://atlascopy.com