Epson PowerLite 85 System manual

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 85/825/826W
Cleaning the Air Filter and Vent
Your projector includes an air ter to ensure the best performance. If
dust collects on th or vent, clean them as described below.
Dust clogs prevent proper ventilation and can cause overheating and
damage the projector.
If you see the following message, clean the air ter immediately.
The projector is overheating. Make sure nothing is blocking the
air vent, and clean or replace the air filter.
1. Turn the projector. Wait for the Ppower light to stop
then unplug the power cord.
2. To clean the intake vent and use a small vacuum cleaner
designed for computers and other e equipment. If you don’t
have one, gently clean the vent with a soft brush (such as an
artist’s paintbrush).
You can remove the air lter to clean both sides. For instructions,
see page 110.
3. If the dirt is di ult to remove or the is damaged, or if the
message appears again after cleaning, replace the lter as described
on page 110. Contact your dealer or call Epson at
800-GO-EPSON (800-463-7766) to purchase
note
To order replacement air
lters, request part number
V13H134A22. See page 13
for ordering information.
The exhaust
vent is on the
other side of
the projector
1

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 85/825/826W
2
Replacing the Air Filter
If the lter is dicult to clean or damaged, or if the overheating
message appears after cleaning, you need to replace the lter. Contact
your dealer or call Epson at 800-GO-EPSON (800-463-7766)to
obtain a new lter.
1. Turn o the projector.
2. When the Ppower light stops ashing, unplug the power cord
3. Open the air lter cover by sliding the switch and pulling down
the cover.

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 85/825/826W
3
4. Grasp the tab and pull the lter straight out.
5. Press in the new air lter until it clicks in place.
6. Close the air lter cover.