Epson MicroTouch IC-215P-AA2 User manual

Epson TrueOrder KDS
Touchscreen User Manual
Page 1 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
About this Guide
This guide contains information on how to use touchscreens with the Epson TrueOrder KDS. It
assumes a Single Station KDS connected to the POS via Ethernet, and that the POS is already
supported by the Epson TrueOrder KDS.
EPSON is a registered trademark and EPSON is a registered logomark of Seiko Epson Corporation. All other product and brand names
are trademarks and/or registered trademarks of their respective companies. Epson disclaims any and all rights in these marks.
Copyright 2023 Seiko Epson Corporation.
111-56-URM-001
Epson TrueOrder KDS
Touchscreen User Manual

Epson TrueOrder KDS
Touchscreen User Manual
Page 2 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
Table of Contents
1. Overview......................................................................................................................3
1.1. Supported Touchscreens......................................................................................................................3
2. Connections................................................................................................................4
2.1. KDS Controllers....................................................................................................................................5
3. Operation.....................................................................................................................6
3.1. Bumping an Entire Order......................................................................................................................7
3.2. Bumping an Individual Item ..................................................................................................................7
3.3. Recalling Orders...................................................................................................................................7
3.4. Recipe Information................................................................................................................................8
3.5. Off-screen Orders.................................................................................................................................8
3.6. Expanded Order View...........................................................................................................................9
3.7. Device Information................................................................................................................................9
4. Compatibility with Bump Bar...................................................................................10
5. Troubleshooting ....................................................................................................... 11
5.1. Screen Does Not Respond to Touch..................................................................................................11
5.2. Screen Does Not Power On ...............................................................................................................11
5.3. Touchscreen Shows a Blank/Black Screen........................................................................................11

Epson TrueOrder KDS
Touchscreen User Manual
Page 3 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
1. Overview
Touchscreens can be used to operate the Epson TrueOrder KDS (Kitchen Display System). They are plug
and play and no special configuration is required. This document describes how to use the various UI
elements that appear when a touchscreen is plugged into the system.
1.1. Supported Touchscreens
- When using KDS All-in-One device, model number IC-215P-AA2 (MicroTouch), no additional
touchscreen or controller box is required. It is an all-inclusive device and needs the least amount of
external wiring: only an ethernet cable and a power cord.
- When using KDS controller boxes, model number MP-000-AA2 (MicroTouch), any touchscreen
capable of full HD (1920 x 1080) can be used. The following are some of the touchscreens we have
tested and qualified:
oMicroTouch SK-215P-A1
oMicroTouch DT-215P-A1
oElo 2202L
oElo 2702L

Epson TrueOrder KDS
Touchscreen User Manual
Page 4 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
2. Connections
Touchscreen monitors typically provide their touch interface over USB. This was traditionally a USB B type
connector at the back of the touchscreen, but USB C is becoming increasingly popular too.
The required cable depends on the connector at the back of the touchscreen monitor. The KDS controller
box always takes the USB A type end of the cable, while the USB B or C type end of the cable goes to the
touchscreen.
Picture 2.2
USB B to touchscreen
USB A to KDS controller box
Picture 2.1
USB C to touchscreen
USB A to KDS controller box

Epson TrueOrder KDS
Touchscreen User Manual
Page 5 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
2.1. KDS Controllers
The MicroTouch MP-000-AA2 KDS Controller has 1 USB A port. The touchscreen should be connected to
the USB A port (red box in Picture 2.1.1). The controller is also equipped with an HDMI connector for the
screen.
Picture 2.1.1: MP-000-AA2 USB port

Epson TrueOrder KDS
Touchscreen User Manual
Page 6 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
3. Operation
Pictures 3.1 and 3.2 show a typical order screen with and without touchscreen. Having a touchscreen
exposes some additional controls in the top control bar viz. Recall button and Tickets -/+ buttons. Using a
bumpbar the Recall button on the bumpbar replaces that on the screen; the Tickets -/+ capability is not
available without a touchscreen.
Picture 3.1: A typical (fixed grid) order screen with touchscreen, bumpbar optional
Picture 3.2: A typical (flex grid) order screen with bumpbar only, no touchscreen

Epson TrueOrder KDS
Touchscreen User Manual
Page 7 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
3.1. Bumping an Entire Order
On a touchscreen, an entire order can be bumped off by tapping the header bar of the order tile, or with a
SWIPE UP gesture on the order tile body.
3.2. Bumping an Individual Item
Pressing on the actual item name will bump it (strike-through) along with all associated modifiers.
3.3. Recalling Orders
Tapping on the RECALL button in the top control bar will bring up the order history window. This screen
shows recently bumped orders. The orders are displayed complete with all details, and items are not crossed
out (no strike-through) on this screen to allow easier review. In recall mode, the RECALL button turns yellow.
Figure 3.3.1: Order History/Recall Window (shown in a dark colour theme)
When an order from the Recall Window is recalled back to the active order window, it is identified by the
same two-tone order header as shown above, and placed in the beginning of the queue i.e., in the first tile.
The keyword “(RECALL)” is also added to the second row of the header when shown in the active order
window. Note that recalled orders on the active order screen will appear crossed out (strike-through).

Epson TrueOrder KDS
Touchscreen User Manual
Page 8 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
3.4. Recipe Information
Pressing and holding on a particular item brings up the recipe information for that item in a modal window.
Pressing the OK button on the recipe window dismisses it and returns focus to the active order window.
Figure 3.4.1: Recipe Window sample
3.5. Off-screen Orders
The left and right arrows in the top control bar can be used to scroll through order pages. The main order
table follows a pagination system, so scrolling right will shift all orders on screen. For instance, if the layout is
7x3 tiles, all 21 tiles will be shifted off-screen, and the next 21 tiles displayed.

Epson TrueOrder KDS
Touchscreen User Manual
Page 9 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
3.6. Expanded Order View
Press and hold the header bar of the order tile to open the order in Expanded Order View. This shows the
entire order in its own modal window and is useful when the operator wants to focus on a single large order
that is otherwise spanning multiple tiles.
Clicking outside the modal window dismisses the Expanded Order View.
Figure 3.6.1: Expanded Order Window
3.7. Device Information
Pressing on the logo in the top left corner of the screen opens the Device Information modal window. This
provides useful information during system setup and troubleshooting.
Clicking outside the modal window dismisses the Device Information window.

Epson TrueOrder KDS
Touchscreen User Manual
Page 10 of 11
111-56-URM-001
R3.00
Form: F-730-028 v1.00
Trademarks
4. Compatibility with Bump Bar
A bumpbar can be used in tandem with touchscreens, should the need arise. It should be noted, however,
that some KDS devices may only provide a single USB A connector –in such cases, a simple line-powered
USB hub can be employed.