ERA 1430-32 User manual

1430-32
Replacement Front Door Lock
Fitting Instructions
Using 2 wood screws provided, fix mounting plate allowing 4.0mm clearance from
the edge of the door, ensuring mounting plate is parallel with the door edge.
It may be necessary to loosen connecting bolts to achieve clearance, ensure bolts
are secure after fixing mounting plate
Note: 2mm diameter pilot holes may be necessary in hardwood doors
D
Re-insert the cylinder into the door and locate the mounting plate on the door,
insert connecting bolts through mounting plate top centre holes into the cylinder.
Do not tighten the bolts
Note: For doors less than 45mm thick, connecting bolts need to be shortened using
hacksaw
C
Place cylinder into ring and push through door. With a pencil, mark the cylinder
bar level with the inside surface of the door. Remove cylinder and cut the bar so
that it will project 12mm beyond the doorface i.e. beyond the pencil mark
Remove mounting plate from lock body by unscrewing the 2 retaining screws
(see ).
Select desired height for the lock. Mark the centre of the cylinder hole from the
edge of the door, 40mm for 40mm Backset Lock and 60mm for the 60mm Backset
Lock. Drill a 32mm (11/4”) diameter hole through the door
B
A
Note: Lock is only suitable for doors up to 57mm thick, or 54mm with cylinder pull
For glass panelled doors use 163/193 for the Double Lock Nightlatch or 1830/1930
for the BS High Security Nightlatch. This product is not suitable for outward opening
doors.
To fit a Replacement Front Door Lock you will require the following tools:
- Drill
- 32mm (11/4”) drillbit
- Rule
- Hacksaw
F
Installing a Replacement Front Door Lock
32mm
40mm/60mm
Edge
ofDoor
40mm
D
C
B
A
ERA, Valiant Way, Wolverhampton, WV9 5GB
Tel: [phone] Fax: [phone] Email: [email protected]
www.eraeverywhere.com

Fitting the Staple
Close door and mark the position of the staple using the lock as a guide. Mark area
of wood to be removed from door frame and chisel out. Insert the 3 remaining
woodscrews provided to fix the staple, drilling the pilot holes is necessary.
G
Slide the lock onto the mounting plate and secure it using the 2 retaining screws
removed earlier.
F
Before attaching to the mounting plate, ensure the arrows line up on the back of
the lock.
Note: If the “Outside Deadlock” facility is required, remove the screw from the back
of the lock and discard it.
E
Note: Deadlocking should not be used while the house is still occupied.
Cleaning - Use a moist cloth only to clean all types of finish, household abrasives or solvents
may affect the surface finish.
Maintenance - Do not take the cylinder apart, do not oil or paint the cylinder, moving parts
can be greased.
Operation (With outside Deadlocking):
To Deadlock - Insert the key and rotate anti-clockwise 360° and remove key. The door
cannot be opened from the inside. To unlock deadlock - Reverse operation.
Hold Back Facility - Withdraw bolt via handle and slide snib.
To Internally Deadlock - Slide Snib (See fix. F) The door cannot be opened from outside.
To Open - Insert key and turn clockwise.
Operation (Non Outside Deadlocking):
Additional Information
G
F
E
ERA, Valiant Way, Wolverhampton, WV9 5GB
Tel: [phone] Fax: [phone] Email: [email protected]
www.eraeverywhere.com