Ergotron StyleView User manual

1
5
6
2
3
4
1
5
2
3
4
20"
(508 mm)
+12˚
5˚
20˚
12˚
180˚
5" (127 mm)
www.ergotron.com
USA: 1-800-888-8458
Europe: [phone]
China: 400-120-3051
Japan: [email protected]
777-24-024-G-00 rev. E • 03/19
STYLEVIEW®
QUICK REFERENCE
ERGONOMICS
Working customize - to your size
1 Set top of monitor screen about one inch below eye level - Release brake
and lift or lower riser as needed.
2 Tilt screen for comfortable viewing and to reduce eye and neck strain.
3 Pull keyboard tray forward and position mouse tray and mouse pouch on
right or left, as needed.
4 Work with elbows bent at about 90° to minimize muscle strain.
5 If the riser moves up and down with diculty, or if it drifts out of set
position, consult the product
manual for adjustment
information.
6 Stay in charge!
Powered carts should be
plugged into outlet as often as
possible to keep battery charged
and computer running.
Moving stow - before you go
1 During normal movement, release brake and lower worksurface to
lowest position for optimal stability and unobstructed view.
2 Tuck away open trays and return mouse, scanner and other
accessories to their places.
3 Unlock both front casters.
4 Push cart from rear with elbows bent at about 90° to maximize
control and minimize muscle strain.
5 Don’t run out!
Before moving, make
sure cord is unplugged
from outlet and hooked
to basket for safe travel.
Remember, charge
battery fully 100%
every day!
RANGE OF MOTION
Loosen knob, tilt Display
to desired position then
retighten knob.
CAUTION! Completely release brake engagement
before raising or lowering the cart. Raising or
lowering the cart with the brake partially engaged
may cause product damage.
Wheel Rotation Wheel Rotation and Swivel Locked

www.ergotron.com
USA: 1-800-888-8458
Europe: [phone]
China: 400-120-3051
Japan: [email protected]
777-24-024-G-00 rev. E • 03/19
STYLEVIEW®
QUICK REFERENCE
This power system interface will alert you to the percentage of charge remaining in the cart battery with a
series of steady or ashing red, yellow or green lights, and an alarm that will beep when charge gets below 30%.
Remember, the battery needs to be charged to 100% every day, and you can use the cart while charging, so plug-in
cord as often as possible to avoid running out of power!
NOTE: Put monitor in power save mode to optimize battery run time.
Battery has 100% charge.
Light ashes when charging (power cord plugged into
wall outlet) Allow battery to continue charging until light
stops ashing. After light stops ashing, it is OK to unplug
the power cord from the wall. You can use cart while
charging.
Battery has less than 90% charge.
Battery has less than 70% charge.
Battery has less than 50% charge.
Battery has less than 30% charge. Light is red and alarm
beeps. Plug-in power cord and charge to 100%! You can
use cart while charging.
Alarm Mute button. Pressing this will temporarily mute
alarm.
Power button for internal power system outlets. Pressing
this will provide or remove power to/from components
plugged into the internal outlets.
When lit, alarm is
enabled and will beep
when battery charge
gets below 30%. For
details on enabling and
disabling alarm contact
Ergotron Customer Care.
When lit, the power
system is on. When dark,
power system is o.
NOTE: Frequent operation of the cart while battery charge levels are below 30% will signicantly reduce
the life of your battery.
KEYBOARD LIGHT
Your computer must be on for this light to function.
Keyboard Light will automatically turn o after 15 minutes if not
manually turned o.