Ergotron StyleView User manual

1
5
6
2
3
4
1
5
2
3
4
5"
(127 mm)
25˚
+12˚
20"
(508 mm)
12˚
STYLEVIEW®
QUICK REFERENCE
For more information on this or other Ergotron products, visit our website: www.ergotron.com
EN
777-24-005-G-00 rev.A • 08/10
ERGONOMICS
RANGE OF MOTION
Working customize - to your size
1 Set top of monitor screen about one inch below eye level - Release brake
and lift or lower riser as needed.
2 Tilt screen for comfortable viewing and to reduce eye and neck strain.
3 Pull keyboard tray forward and position mouse tray and mouse pouch on
right or left, as needed.
4 Work with elbows bent at about 90° to minimize muscle strain.
5 If the riser moves up and down with diculty, or if it drifts out of set
position, consult the product
manual for adjustment
information.
6 Stay in charge!
Powered carts should be
plugged into outlet as often as
possible to keep battery charged
and computer running.
Moving stow - before you go
1 During normal movement, release brake and lower worksurface to
lowest position for optimal stability and unobstructed view.
2 Tuck away open trays and return mouse, scanner and other
accessories to their places.
3 Unlock both front casters.
4 Push cart from rear with elbows bent at about 90° to maximize
control and minimize muscle strain.
5 Don’t run out!
Before moving, make
sure cord is unplugged
from outlet and hooked
to basket for safe travel.
Remember, charge
battery fully 100%
every day!
Release Brake to move riser.
Loosen knob, tilt
Display to desired
position then
retighten knob.

123
4
1
1
12
2
3
456
STYLEVIEW®
QUICK REFERENCE
For more information on this or other Ergotron products, visit our website: www.ergotron.com
EN
777-24-005-G-00 rev.A • 08/10
Battery has 100% charge.
Light ashes when charging (power cord plugged into wall outlet) Allow
battery to continue charging until light stops ashing. After light stops
ashing, it is OK to unplug the power cord from the wall. You can use cart
while charging.
Battery has less than 90% charge.
Battery has less than 70% charge.
Battery has less than 50% charge.
Battery has less than 30% charge. Light is red and alarm beeps. Plug-in power
cord and charge to 100%! You can use cart while charging.
Alarm Mute button. Pressing this will temporarily mute alarm.
Power button for internal power system outlets. Pressing this will provide or
remove power to/from components plugged into the internal outlets.
When lit, alarm is enabled and
will beep when battery charge
gets below 30%. For details on
enabling and disabling alarm
contact Ergotron Customer Care.
When lit, the power system is on.
When dark, power system is o.
This power system interface will alert you to the percentage of charge remaining in the cart battery with a series of steady
or ashing red, yellow or green lights, and an alarm that will beep when charge gets below 30%. Remember, the battery
needs to be charged to 100% every day, and you can use the cart while charging, so plug-in cord as often as possible to avoid
running out of power!
NOTE: Put monitor in power save mode to optimize battery run time.
READY ON
Pressing this button
will wake up your
computer from
hibernate or power
o.
KEYBOARD LIGHT
Your computer must be on for this light to function.
Keyboard Light will automatically
turn o after 15 minutes if not
manually turned o.
Lock Drawer:
• Wait 4 seconds for lock to engage automatically.
NOTE: Drawer must be fully closed to lock.
Unlock Drawer (3 methods):
• Enter Master PIN, then press desired drawer number*.
• Enter User PIN, then press desired drawer number*.
• Key - turn clockwise 1/4 turn
*Drawer Numbers:
NOTE: Frequent operation of
the cart while battery charge
levels are below 30% will
signicantly reduce the life
of your battery and may void
your battery warranty.