esky KING 3 User manual

R/C helicopters, including the ESKY Helicopter are not toys. R/C helicopters utilize various high-
tech products and technologies to provide superior performance. The rotating blades on the model
spin at high speed can cause potential risk or injury if used improperly. It is mandatory that you
observe all R/C safety rules and adhere to local laws as applicable. We recommend that you contact
your local hobby store and inquire about safety rules, regulations and local laws and statutes
regarding R/C model operation in your area. Please make sure to be conscious of your own
personal safety and the safety of others and your environment when operating all ESKY products.
If used properly, ESKY R/C products will provide years of R/C entertainment.
We recommend that you obtain the assistance of an experienced pilot before attempting to fly
our products for the first time. A local expert can assist you to properly assemble ,set up, and fly
your model for the first time.
The HONEYBEE CP3 requires a certain degree of skill to operate, and is a consumer item. Any
damage or dissatisfaction as a result of accidents of modifications are not covered by any warrantee
and can not be returned for repair or replacement. Please contact our distributors for free technical
consultation and parts are at discounted rates when you experience problems during operation or
maintenance.
It is not the policy or practice of ESKY HOBBY to exchange or return parts after the package has
been opened. In case you discover any parts that might be defective or missing, please contact the
retailer who sold you the product. Get their signature on your Customer's Card and contact ESKY
HOBBY with a description of the problem parts.

DC12V Power 12V
If the red POWER light does not turn steady when the charger connected with the DC 12V power
supply, it indicates improper connection exists or the power supply does not work well. Please
check and reconnect until it works properly.
Power Charger
If the red POWER light and the green Charge indicator flash at the same time when the battery
connected with the charger, it indicates the battery may be defective. Please check the battery
and ensure it is in good condition.
Keep it in a cool, dry and ventilated place while charging. Keep it far away from heat and
inflammables.
ESKY
Please use original ESKY charging equipments for charging and flying in case of unexpected
damage or injury.
It needs great care while charging. Never leave it unattended in the process of charging.
Please disconnect the power supply immediately and move to safe place in case you find
something abnormal.
However it is normal for the charger and battery to get warm while charging.
Charger Power
DC12V 3 5
If the red POWER light flashes while the green CHARGER light is not on when the battery connected
with the power supply, it indicates the battery is in state of Protection. Please disconnect the DC 12V
power supply and reconnect it 3-5 seconds later.
Charger
4.15V
The green Charge indicator will turn steady once the battery is fully charged.Please take off the
battery from charger. It will discharge automatically if not disconnected in time and re-charge as
the single cell voltage is less than 4.15V until fully charged. Theprocess repeats if not disconnected.
Please take off the battery from the helicopter before charging. NEVER charge the battery while
connected with the helicopter.
Do NOT charge on a carpet, cluttered workbench, paper, plastic, vinyl, leather, wood, and the like.

The connect port of Pitch servo
Gyro gain of tail motor wire
Throttle connect port
Elevator servo
Aileron servo
Rudder channel