ESP duceri EMDLED3WMBULK2 User manual

www.espuk.com
Month Test
Sign Date Sign Date Sign Date Sign Date Sign Date
1 Functional 2 Functional 3 Functional 4 Functional 5 Functional 6 1 hour 7 Functional 8 Functional 9 Functional
10 Functional 11 Functional 12 3 Hour
1st year 2nd Year 3rd Year 4th Year 5th year
LuminaireType/Ref: Date of Installation: Location:
TEST RECORD SHEET
Rated input supply: AC 240V 50Hz
Rated output power: 8 x SMD 2835 LED
Operating Environmental: Temperature:- 0-40 °C
Operating relative humidity: Less than 90%
Emergency Duration: More than 3 Hours.
Change over time: Less than 1 second.
EMDLED3WMBULK2
3W LED IP65 Maintained Emergency Bulkhead
GENERAL INFORMATION
Our products are designed to comply with the recommended codes of practice
for emergency lighting of premises and be installed by competent person in
accordance with the relevant wiring regulations.
LUMINAIRE INFORMATION
Battery Specification: 3.6v 1200mAh NI-CAD Batteries
MONITORING
Green indicator lamp (LED) normally continuously ‘on’. Indicator lamp goes
out if A.C. supply or charger fails.
For additional product information please visit the ESP website
www.espuk.com/technical_support/product_manuals/?cat=5
K19
IP65

WARNING
• This product must be disconnected from the circuit if subjected to any high
voltage or insulation resistance testing. Irreparable damage will occur if this
instruction is not followed
• Recommended routine test procedure in accordance with BS 5266
• Daily check - check that the status GREEN LED indicator is illuminated
• Monthly functional test - simulate a mains supply failure for approx. 30 secs by
operation of a key switch or circuit breaker.Ensure normal supply
is restored after test and the indicator status LED is illuminated.
• Twice yearly conduct a one hour duration test - simulate a mains supply failure
breaker. Ensure normal supply is restored after test and the indicator status LED
is illuminated
• Annual full three hour duration test - conduct a three hour continuous
duration test. Simulate a mains supply failure for three hour continuous test by
r. Ensure normal supply is
restored after test and the indicator status LED is illuminated
•
GENERAL
the correct manner when it reaches the end of its life. Check local authorities for
where facilities exist. Clean with a soft dry cloth only , do not use aggressive cleaning
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by the end
user for future reference and maintenance.
SAFETY
•
or competent person to the current IEE Wiring Regulations
• Please isolate mains prior to installation/maintenance
•
not exceed the rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this luminaire when deciding
the location for installation
electrician. See overleaf for test record sheet
INSTALLATION
• Provide power to the required point of installation. Suitable IP rated junctions
boxes should be used where required
•
with any joists, gas or water pipes or electrical cables
• For non-maintained operation please wire up connector block as shown in Fig 3
• For maintained operation (luminaire always on) please see Fig 4
• For switchable maintained operation
see Fig 5
• Connect the battery via the plug and
socket on the PCB
• Switch on the power supply and ensure
the LED indicator is illuminated Green
• Remove two screws
• Pull apart tabs (see Fig 2) to
gain access to the connections
Fig 1 Fig 2
Fig 3
Fig 4
Fig 5
Insert link
cable
Remove screws Pull apart tabs
• Switch on the power supply and ensure the LED indicator is illuminated green. If it is not
illuminated green, there may be a supply or battery fault