Etac Turner PRO Instructions for use

Turner PRO
2
Wheels / Wheel axles
3
Rotating mechanism
2
If turner rotates porly:
• Unscrew bolt (5).
• Clean Low friction disc (2) and floor plate (1).
• If deep groves or damages in (1) or (2), replace
(1,2,3,4,5).
• Apply loctite 243 or simular on bolt (5), tighten bolt
firmly (approx 20Nm).
If antislip knobs are missing or worn down:
• Flip out old knobs (3).
• Clean holes and push in new knobs.
Washing
1
• Lay the Turner PRO on the floor in an angeled position
after washing, so the water runs out of the rotating
mechanism.
• You may also use copressed air to blow dry inside
rotating mechanism.
• Controls wheel and shaft for wear.
• Check if the wheels turn easily, remove hair and dirt.
If wheels are worn out, or still rotates porly after
cleaning:
3
1
5
4
2
• Use a solvent-free detergent with a pH level bet-
ween 5 and 9.
• Can be washed at 70° C for 10 minutes.
3
1
2
• Flip out starlock with
an screwdriver or
simular (1).
• Remove bolt and
wheel.
• Replace 1,2,3.
• Place wheel between
forks.
• Insert bolt and knock
.starlock in place.
EN
Reconditioning

Turner PRO
3
Leg Support
4
Main plate/outer pole
5
• Check bracket on leg support for cracks and
wear. If cracs, replace coplete leg support.
• Check cushion for wear, should be tight and firm
around the pipe. If loose or damaged, replace
cushion.
Original spare parts from Etac should always be used.
Handle/inner pole
6
• Check for cracs and dents, if cracs or dents
replace inner pole.
2
3
1
If complete leg support needs to be replaced:
• Unscrew bolts and remove outer pole.
• Pull leg support out of pole.
If cushion need to be replaced:
• Flip out knob (3) and remove cushion.
• Clean pipe, insert new cushion and knock knob in
place.
• Insert leg support with kneepads pointing upwards
• Make sure both knobs are on the same side (1).
• Tighten knob by turning knob clockwise (2).
• Place the base plate on an even surface. Insert
pole with knee pads facing away from
the wheels.(1)
• Insert all three screws into holes in the base
plate. Use allen key to screw in bolts. Apply
loctite 243 or simular on bolts, tighten
bolt firmly, (approx 20Nm). (2)
12
12
• Check for cracks and wear on main plate and
outer pole. If cracks, replace complete Turner-
PRO.
• Check bolted conection between pole and
main plate (3 bolts), if loose bolts tighten all
bolts.
EN
Reconditioning
Reconditioning