EtherWAN EL2321 User manual

EL2321 www.etherwan.com
W70G-EL2321XQ2
1
This quick start guide describes how to install and use the OAM Managed 10/100/1000BASE-TX to 100/1000BASE-FX Dual Rate Media
Converter. The converter introduced here provides one channel media conversion solution.
Physical Description
Product Overview
This media converter is a plug-and-play device. Connect the supplied AC to DC power adaptor to the receptacle on the rear panel of the media
converter, and then attach the plug into a standard AC outlet.
Functional Description
 Complies with IEEE802.3 10BASE-T, 802.3u 100BASE-TX, 802.3ab 1000BASE-T, 802.3z 1000BASE-X
 Complies with IEEE 802.3ah OAM standard
 Supports SNMP V1, V2 Management
 Supports IN-BAND Loop Back and Diagnostic
 Gigabit transmission supports 9K bytes jumbo frame
 One fiber interface supports dual rate 100BASE-FX and 1000BASE-SX/LX fiber transmission
 Supports IEEE802.3x Flow controls: Flow control for full duplex and Back pressure for half duplex
 Auto-Negotiation, Auto-MDI/MDIX
 Full wire-speed forwarding rate
 Supports Wall Mounting installation or use with EMC1600 media converter chassis system.
The 10/100/1000Base-TX and 1000Base-SX/LX/BX Connectors
The 10/100/1000Base-TX Connection
The following lists the pinouts of 10/100/1000Base-TX port.
Pin Label
1 TP0+
2 TP0-
3 TP1+
4 TP2+
5 TP2-
6 TP1-
7 TP3+
8 TP3-
The 100Base-FX Connection
The 1000Base-SX/LX Connection
The Tx (transmit) port of device I is connected to the Rx (receive) port of device II,
and the Rx (receive) port of device I to the Tx (transmit) port of device II.
The WDM 100Base-BX Connection
The WDM 1000Base-BX Connection
Only one optical fiber is required to transmit and receive data.
The SFP Connection
The SFP socket for 100Base and 1000Base fiber optic expansion.
For SFP expansion

EL2321 www.etherwan.com
W70G-EL2321XQ2
2
The Port Status LEDs
LED’s State Indication
PWR (Green) Steady Power On
Off Power Off
Copper Port Speed
Steady Green: Copper Port connection at the speed of 1000Mbps
Amber: Copper Port connection at the speed of 100Mbps
Off Copper Port connection at the speed of 10Mbps
LNKC (Green) Steady A valid network connection is established on TX port
Flashing Data transmitting
OAM LOOP
(Green)
Steady When device in OAM Active Mode
Flashing Blinks for 4 seconds if loopback testing pass, when device in OAM
Passive Mode
GE Steady Fiber port connection at the speed of 1000Mbps
Off Fiber port connection at the speed of 100Mbps
LNKF (Green) Steady A valid network connection is established on FX port
Flashing Data transmitting
LFPT (Green) Steady LFPT function enabled
Off LFPT function disabled
Web Configuration
Login the media converter:
 Specify the default IP address (192.168.1.10) of the media converter in the web browser. A login window will be shown as below:
 Enter the factory default Username (admin). Enter the factory default Password (no password). Then click on the “Login” button to log on to
the OAM managed dual rate media converter.