EtherWAN EL1032T Series User manual

Copyright 2019 EtherWAN Systems, Inc. Page 1
All Rights Reserved
EL1032T
03/28/2019
W70G-EL1032TQ1
EL1032T Series Media Converter
Installation Guide
1 Unpacking
Open the carton and unpack the items. Your
package should include an EL1032T media
converter and this Quick Install Guide. If items
are missing or damaged, notify your EtherWAN
representative.
Download the full manual at:
https://www.etherwan.com
2 Select Installation Location
Place the equipment where it will not be
subjected to extreme temperatures, humidity, or
electromagnetic interference. Specifically, the
site you select should meet the following
requirements:
The ambient temperature should be between
-10 and 60 degrees Celsius (14 to 140 degrees
Fahrenheit).
The relative humidity should be less than 95
percent, non-condensing.
Make sure that the equipment receives
adequate ventilation. Do not block the
ventilation holes on each side of the
equipment.
3 Connect Power
There are two power inputs for this device, a 3-
pin terminal block and a 4-pin latched DC jack.
Input voltage on the terminal block is:
48~52VDC for IEEE802.3af (15.4W)
52~57VDC for IEEE802.3at
Input voltage for latched DC jack is:
48VDC +/- 10%
4Ports and Port Settings
The Converter provides one TX port and one FX
port. The TX port uses RJ-45 connector.
Port settings are made by means of a DIP (Dual
Inline Package) switch at the rear panel of the
module.
5 DIP Switch Settings
DIP
Switch
ON
OFF
1
Enable forced
mode for TX port
Enable auto
negotiation for TX
port
2
TX port forced to
10Mbps
TX port forced to
100Mbps
3
TX port forced to
half duplex mode
TX port forced to
full duplex mode
4
Enable Link-Fault-
pass-Through
Disable Link-Fault-
pass-Through

Copyright 2019 EtherWAN Systems, Inc. Page 2
All Rights Reserved
EL1032T
03/28/2019
W70G-EL1032TQ1
EL1032T Series Media Converter
Installation Guide
6 LED Indicators
LED
State
Indication
Power
1/2
Steady
Power on
Off
Power off
PoE
Steady
Powered device is
connected
Off
Powered device is
disconnected
Link/ACT
Steady
Valid network connection
established
Flashing
Transmitting or receiving
data
Off
Neither valid network
connection nor
transmitting/ receiving
data
Manufacturer information:
ETHERWAN SYSTEMS, INC.
4F-7, No. 79, Sec. 1, Xintai 5th Road, Xizhi
District, New Taipei City 221, Taiwan