EURO EAF600SS User manual


























&RRNHU+RRG
0RGHO

EAF600SS
EAF600WH

2
Specification: 220-240V~50 Hz 165W
In certain circumstances electrical appliance may be a danger hazard.
Information and advice
A) There shall be adequate ventilation of the room when
the range hood is used at the same time as appliances
burning gas or other fuels.
B) Do not check the status of the filters while the cooker
hood is operating.
C) Do not touch the light bulb within half an hour after
appliance use.
D) Do not flambé under the cooker hood.
E) Avoid opening gasometer when there is no pan on the
stove, as it is damaging for the filters and a fire hazard.
F) Constantly check food frying to avoid that the overheated
oil may become a fire hazardDŽ
G) Disconnect the electrical plug prior to any
maintenance.
H) If the supply cord is damaged, it must be replaced by
the manufacture, its service agent or similarly qualified
persons in order to avoid a hazard.
I) The socket outlet for the range hood must be located so it is
easily accessible for the user after installation. Ensure the
mains supply voltage corresponds with that of the appliance.
J) There is a fire risk if cleaning is not carried out in
accordance with the instruction.
K) This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by person responsible for
their safety.

3
L) Children should be supervised to ensure that they do not
play with the appliance.
M)This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved.
N) Children shall not play with the appliance.
O) Cleaning and user maintenance shall not be made by
children without supervision.
CAUTION: Accessible parts may become hot when
used with cooking appliance.
Please keep this instruction booklet in a safe place for future reference.
Please read this instruction manual careful: it contains important information
concerning the safe operation, installation and maintenance of the appliance.
P) When the hood is in repair,maintenance,replacement of
parts,please pull out the plug,ensure the safety of the people.
Q) To pritect the main body from corrosive of the long time
accumulation of dirt,the cooker hood should be cleaned with
hot water with non-corrosive detergent every two months.

Please read these instructions before using your cooker hood.
1. Air duct assembly
2. Main body
3. Filter assembly
Congratulations on the purchase our cooker hood which is designed to include many
superior features that permit you the fullest expression of your living.
Before installing and/or using the cooker hood carefully read all the instruction.
,QIRUPDWLRQ
Know your cooker hood
4
Also include:
z
z
z
zUser instructions
Check valve
Air outlet cap
Install screws package

Fully convertible for vertical, horizontal or ductless operation.
A. Vertical discharge
B. Horizontal discharge
C. Ductless
The air must not be discharged into a flue that is used for exhausting fumes from
appliance burning gas or other fuels. Regulation concerning the
have to be fulfilled.
discharge of air
Information
Selection of venting direction
5

Vertical discharge
Vertical is the most common.
If you select this venting direction,
you only need to open ducting
knockout by inserting a flat head
screwdriver under one end and prying
it up. Then snip or break the attachment
points by tin snips. You must make sure
that the ducting knockout B is not removed.
Horizontal discharged
Assuming that the range hood is located
against an outside wall, horizontal discharge
is preferred provided that there are no
obstructions such as wall joists, or where
opening are difficult to make.
If you select this venting direction, you only
need to open the ducting knockout B.
Same with removing the ducting knockout A,
you must make sure that the ducting knockout
A is not removed.
Sufficient air is needed for proper combustion and exhaustion of gases through the
flue (chimney) of fuel burning equipment to prevent back drafting.
,QIRUPDWLRQ
z
z
6

Ductless
In a ductless installation the air is re-circulated
back into the kitchen. If you do not anticipate
heavy cooking this method will be preferred.
It will not be necessary to remove any duct
knockouts, you only need chose knockout C.
You should use filters to help remove cooking
odors. These filter must be washed and replaced
at regular intervals.
After selecting venting direction and completing
installation, you can turn the knob to achieve
ductless or duct. Open the filter, then you can see the knob.
The knob arrowhead, then it is duct.
The knob arrowed , then it is ductless.
Ductless fans must always be vented to the outdoors.
,QIRUPDWLRQ


z
7

Ensure the power has been turned off before beginning this installation.
Installation work and electrical wiring must be wiring must be done by qualified
person(s) in accordance with all applicable codes and standards, including firerated
construction.
,QIRUPDWLRQ
Installation
To install this hood you will require two
assistants. You will need the following
tools and material to complete this
installation: *Drill*Flat head screwdriver
*Phillips head screwdriver or cordless
drill and Phillips head bit*Tin snip*3/8”
nut driver or ratchet with extension
*measuring tape*hand saw or jig saw*
electrical tap*duct tape
1. Remove the range hood from the carton.
2. Lay the hood upside down on a table
covered with cardboard or paper to prevent
scratching of the table or hood.
3. Hood installation should be within 0.8m
radius range.
4. We recommend that after installation
the bottom of the hood should be no less than
650mm and no more than 750mm above
the stove’s heating elements and burners.
8
Plug must be
assembled in places easy to drag and insert .

,QIRUPDWLRQ
The exhaust air is conducted upwards via a ventilation
shaft or directly through the outside wall into the
atmosphere.
The exhaust air must not be conveyed into a function
smoke flue or exhaust-gas flue or into a shaft which
vents a room with a fireplace.
Conveyance of exhaust air in a non-functioning smoke
flue or exhaust-gas flue requires the prior consent of an
appropriate heating engineer.
If the extractor hood is in exhaust-gas mode and a
flue-type heater is running at the same time (e.g. gas, oil
or solid-fuel heaters, continuous-flow heaters, water
heaters), ensure that the fireplace has an adequate air
supply for combustion.
Safe operation requires that the low air pressure in the
room in which the fire place is located does not exceed 4
Pa.
This low air pressure can be obtained, provided
combustion air can escape through non-lockable
openings, e. g. in doors, windows, air-intake/exhaust-air
wall boxes or by other technical procedures, such as
reciprocal interlocking, etc.
Exhaust-air mode
When assessing the air pressure, the entire ventilation system in the house/apartment must be
taken into account, e.g. hob and/or gas cooker, this rule does not apply.
Government regulations must be observed for the conveyance of exhaust air
If the extractor hood is used in circulating-air mode-with activated carbon filter-, there are no
operating restrictions.
9

2. Hang the hood and let it’s 4 key holes aim
at screws, the 4 screws should be in the
narrow parts of key holes. Screws should
be fasten firmly, make sure that the
installation between the hood and cabinet is
enough fasten.
3. Install screws in the security holes, in case
of front and back moving of hood, so that
the using is safer.
When cutting or drilling into wall or ceiling, do not damage electrical wiring or other
hidden utilities.
,QIRUPDWLRQ
1. According to the figure, make sure the position
of hood in the cabinet. The wood strips should
be line up with the 4 keyholes slots on the top
of the range hood. On the cabinet, install 4
screws(supplied)according to the relative position
of 4 key holes on the bottom of hood. The extent
of screwing should be convenience to the next
installation.
10
Method 1

The cooker hood must not be installed and connected to flues where other appliances
are installed and which run off other energy supplied different to electricity(water
heater boiled cookers(range/agas)etc.).
,QIRUPDWLRQ
In the installation surface in
cabinet don’t adapt to install
the cooker hood, then as per fig,
fix the position of cooker hood
on the wall. On the wall, install
2 screws(supplied) according to
the relative position of 2 key holes
on the back of hood. The extent
of screwing should be convenience
to the next installation. Also install
screws in the security holes, in case
of front and back moving of hood,
so that the using is safer.
11
Installation of hoods built in combi cabinets is the same as previous method.
Method 2

Turn the hood ON when cooking at high heat or when cooking flaming floods.
1. Adjust the knob to be right position.
2. Insert the power plug firmly.
Replacing Bulb:
Hood Using Method
Press the switch of light to be on, the bulbs light on. Otherwise the bulbs don't work.
When press the push button “ ”:on, the motor runs at low speed. When press the push
button “ ” on, the motor runs at middle speed. button “ ” on,
When press the push “ ” on ,the motor stops running.
Replacing Bulb
Switch off the extractor hood and isolate
4.Reconnect the power by inserting the mains
plug or by switchingonthe fuse.
the extrator hood by pulling out the mains
plug or switching off the fuse.
1.
2 Remove the grease filter.
3.Replace the lamp(commercially available
candle lamps,max.40 watts,E14 lampholder).
.
12
When press the push
the motor runs at high speed.

Disconnect range hood from power supply before cleaning or servicing.
1. Cleaning the surface of hood frequently. Use mild soap or detergent to clean the hood.
2. Do not use harsh alkalis or abrasives
3. Avoid the use of scouring powers or dishwasher compounds.
4. Grease filter may be washed using mild soap or detergent. (heavy grease build-up
may not be cleaned easily and the filter may require replacement)
5. Charcoal filter cannot be cleaned and must be replaced regularly.
When cleaning water must not inter into motor, control switch etc. electrical parts.

,QIRUPDWLRQ
Cleaning Instruction
Clean ventilation fans frequently. Grease should not be allowed to accumulate on fan
or filter.

,QIRUPDWLRQ
13

zIt is recommendable to clean the metallic filter every three months by carrying out the
following instruction:
—Remove the metallic filter from the cooker hood and wash it in a solution of water
and neutral liquid detergent, leaving to soak
—Rinse thoroughly with warm water and leave to dry.
—The metallic filter may alter in color after several washes.
This is not cause for customer complaint or replacement of metallic filter.
There is a fire risk of cleaning is not carried out in accordance with the instructions.
Information
14

The manufacturer shall decline all responsibility if the foregoing
recommendations and instruction regarding installation, maintenance and
use are not observed and respected when using the cooker hood.