EURO EP900ISX2 User manual

Island Rangehood
Instruction Manual
EP900ISX2
EURO APPLIANCES BY EUROSTYLE GROUP

CONTENT
1 .............................................. Notice
2 .............................................. Installation Requirements
3 .............................................. Installation – Fitting the Rangehood.
4 .............................................. Safety Warning
5 .............................................. Instructions for Use
6 .............................................. Maintenance
7 .............................................. Troubleshooting

(1) Notice
1. Thank you for choosing our Island Rangehood. Please read
this instruction manual carefully before use.
2. The installation work must be undertaken by a qualified and
competent installer in compliance with applicable Australian
Standards.
3. Euro Appliances disclaims all liability for any damage or
injury caused as a result of not following these instructions for
installation.
This Rangehood is suitable for connection to a 240V, 50Hz
power supply with a proper earth.
Contents
1 x Island Rangehood
1 x Packet of Screws, Fittings & Brackets
1 x plastic outlet with plastic flaps
1 x Set of Chimney Pieces (Upper & Lower)
1 x Operating & Installation Instructions

(2) Installation - Requirements
Warning: This Rangehood is suitable for indoor island installation
only in accordance with the following:
•Installation must be performed by a qualified competent installer.
•If installed above a barbecue, the minimum distance from the
cooking grid/plate is 120cm.
•If installed above a cooking appliance, the minimum distance
from the cooking surface is 65cm.
1. Before installation, please ensure the area is clean to avoid
suction of any debris such as bits of broken wood, sawdust,
etc.
2. Flexible duct bending should be ≥120°.
3. There shall be adequate ventilation of the room when the
Rangehood is used at the same time as appliances burning gas
or other fuels (not applicable to appliances that only discharge
the air back into the room).
4. The air must not be discharged into a flue that is used for
exhausting fumes from appliances burning gas or other fuels
(not applicable to appliances that only discharge the air back
into the room).
5. Regulations concerning the discharge of air have to be
fulfilled.

(3) INSTALLATION
This Rangehood must be placed at a distance of 65cm minimum from the
cooking surface of a cooker/hotplate and 120cm minimum from the
cooking surface of a BBQ.
3.1 The ceiling must be able to bear at least 40kgs weight. Cut a
170mm round hole in the ceiling.
3.2 To fix the hanging board, drill 12 holes in the ceiling using the
plate as a template (refer to pic 2). Use the 12 ST6x40mm screws
and fittings to fix the hanging board on the ceiling.
3.3 Use 8pcs of M4x10 screws and M4 nut with washer to connect
the angle iron onto the corners of the hanging board (refer to pic 2).
3.4 Calculate the length of the angle iron (refer to pic 1) and use
16pcs M4x10 screws and M4 nut with washer to connect one length
of angle iron to another. The overlap length of angle iron must not
be less than 100mm.
3.5 Fit one side of the flexible duct (not included with the
Rangehood) through the 170mm hole in the ceiling (refer to pic 3).
3.6 Use 4pcs of ST4x8 screws to attach the internal chimney onto
the hanging board. Slide the external chimney over the internal
chimney and fit one 1pcs of ST4x8 screw to stop it from falling
down (refer to pic 4).
3.7 Attach the plastic outlet to the top of the Rangehood using
4pcs ST4x8 (refer to pic 5).
3.8 With assistance, hold up the Rangehood body and attach it to
the angle iron frame using 16pcs M4x10 screws and tighten them
securely (refer to pic 6).
3.9 Lower the flexible pipe onto the plastic outlet. Carefully
remove the screw from the external chimney and lower it down into
place. The installation is now finished, refer to pics 7 & 8.

Warning: Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
After installation, make sure that the Rangehood is level to avoid
grease collecting at one end.

(4) Safety Warnings
•
••
•This Rangehood is for domestic use only, it is not suitable for
commercial purposes.
•
••
•Please ensure that installation is performed by a qualified
competent installer.
•
••
•The Rangehood and its filter mesh should be cleaned regularly
in order to keep it in good working order.
•
••
•Before cleaning, please switch the power off at the main
supply.
•
••
•Clean the Rangehood according to the instruction manual.
There is a fire risk if cleaning is not carried out in accordance
with the instructions.
•
••
•If there is any fault with the appliance, please switch off
immediately, disconnect and call the service department to
arrange a service.
•
••
•DO NOT flambé under the Rangehood.
•
••
•CAUTION: Accessible parts may become hot when used with
cooking appliances
•
••
•This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
•
••
•Children should be supervised to ensure that they do not play
with the appliance. Never let the children operate the
Rangehood.
•
••
•If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.

（
（（
（5）
））
）Instructions for Use
Switch on the power to the Canopy.
1. Push the low button, the indicating light around the button will
illuminate and the motor runs at low speed. Push it again and
the motor will stop and the light will switch off.
2. Push the middle button, the indicating light around the button
will illuminate and the motor runs at mid speed. Push it again
and the motor will stop and the light will switch off.
3. Push the high button, the indicating light around the button
will illuminate and the motor runs at high speed. Push it again
and the motor will stop and the light will switch off.
4. Push the light button; the indicating light around the button
will illuminate and the two lighting lamps will switch on. Push
it again and the lamps will switch off.
Low Speed Mid Speed High Speed Light

(6) Maintenance
6.1 Cleaning the filters
The filter mesh is made of high-density stainless steel. Please do not
use corrosive detergent on it. Keeping this filter clean will keep the
appliance running correctly. Please strictly follow the guidelines
below.
Method 1: Put the mesh into a sink of clean water, pour on
detergent, and soak for 2-3 minutes. Wear gloves and clean with a
soft brush. Please do not apply too much pressure, as the mesh is
delicate and can be easily damaged.
Method 2: Wash in a dishwasher with the temperature set to around
60 degrees.
6.2 Cleaning the Rangehood
1. To protect the main body from corrosion, the Rangehood
should be cleaned with hot water plus non corrosive
detergents every two months.
2. Please do not use abrasive detergent because it will damage
the Rangehood.
3. Keep water away from motor and other electrical parts as
this will cause damage to the appliance.
4. Before cleaning the appliance please remember to shut off
the power and disconnect the plug.
5. Do not expose the carbon filter to heat.
6. Please don’t tear open the fixed bar around the carbon filter.

7. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
6.3 Replacing the Carbon Filter
1. Detach the metallic anti-grease filters by pressing the lock
and pulling downwards.
2. Fit the carbon filters by the rotating the locks in the casing.

(7) Troubleshooting
Warning: Service must be performed by an authorised
competent person.
Fault
Cause
Solution
Light on, but motor
does not work
The flaps are blocked Remove the blockage.
The capacitor is damaged Call for service.
The motor is jammed due to
bearing damage Call for service.
There is a bad smell coming
from the motor Call for service.
Light does not work,
motor does not work
Beside the above mentioned, check the following:
Light damaged Call for service.
Power cord not connected Check plugged in and
switched on that power is
available.
Oil leakage Filters saturated with cooking oils. Clean the filters.
Leakage between the
connection of U-shaped
section and rangehood
Remove U-shaped
section and seal
Vibrations The flaps are damaged and
causes shaking Call for service.
The motor is not fixed
securely to the rangehood
body
Call for service.
The rangehood body is not
fixed securely to the wall Notify your installer.
Insufficient suction The distance between the
rangehood and the cooking
surface is too much
Notify your installer.
Too much ventilation from
open doors or windows Close doors or windows, choose an alternative
location, if possible,
away from draughts.

The rangehood
inclines The fixing screws are not tight enough Notify your installer.
The hanging screws are not
tight enough Notify your installer.
Eurostyle Group trading as Euro Appliances
Service Line: [phone]
Fax: [phone]
Email: adm[email protected].au