EURO ES602SS User manual

1
Slide-out Rangehood
Instruction Manual
ES602SS
ES602WH
EURO APPLIANCES BY EUROSTYLE GROUP

2
CONTENT
1 .............................................. Notice
2 .............................................. Installation Requirements
3 .............................................. Installation – Fitting the Rangehood.
4 .............................................. Safety Warning
5 .............................................. Instructions for Use
6 .............................................. Maintenance
7 .............................................. Troubleshooting

3
(1) Notice
1. Thank you for choosing our Slide-out Rangehood. Please read
this instruction manual carefully before use.
2. The installation work must be undertaken by a qualified and
competent installer in compliance with applicable Australian
Standards.
3. Euro Appliances disclaims all liability for any damage or
injury caused as a result of not following these instructions for
installation.
This Rangehood is suitable for connection to a 240V, 50Hz
power supply with a proper earth.
Contents
1 x Slide-out Rangehood
1 x Packet of screws & fittings
1 x Plastic outlet with flaps
1 x Operating & Installation Instructions

4
(2) Installation - Requirements
Warning: This Rangehood is only suitable for installation indoors
in accordance with the following:
•Installation must be performed by a qualified competent installer.
•If installed above a barbecue, the minimum distance from the
cooking grid/plate is 120cm.
•If installed above a cooking appliance, the minimum distance
from the cooking surface is 65cm.
1. Before installation, please ensure the area is clean to avoid
suction of any debris such as bits of broken wood, sawdust,
etc.
2. Flexible duct bending should be ≥120°.
3. There shall be adequate ventilation of the room when the
Rangehood is used at the same time as appliances burning gas
or other fuels (not applicable to appliances that only discharge
the air back into the room).
4. The air must not be discharged into a flue that is used for
exhausting fumes from appliances burning gas or other fuels
(not applicable to appliances that only discharge the air back
into the room).
5. Regulations concerning the discharge of air have to be
fulfilled.

5
(3) Installation – Fitting the Rangehood
This Rangehood must be placed at a distance of 65cm minimum from the
cooking surface of a cooker/hotplate and 120cm minimum from the
cooking surface of a BBQ.
3.1 Fixed to Wall.
3.1.1 Drill 4 x 8mm holes into the wall according to dimensions shown
below.
3.1.2 Insert the wall plugs supplied into the holes. Ensure that you use
appropriate fittings for the type of wall which will easily support the
weight of the Rangehood.
3.1.3 Fit the two metal brackets to the top of the Rangehood with the
13mm long screws supplied.
3.1.4 Insert the two lower 30mm long screws supplied into the wall
plugs/fitting, tighten the screws but leave a slight gap for the Rangehood
to hook on to the screws.
3.1.5 Lift the Rangehood onto the screws and fully tighten the screws.
3.1.6 Fit the two upper 30mm long screws supplied through the bracket
and into the wall plugs/fittings and tighten the screws.
3.1.7 Fit the plastic outlet to the top of the Rangehood by snapping it into
the hole. Make sure the outlet is fitted all the way around.
3.1.8 Fit the Flexible Duct (not supplied) to the outlet.
3.1.9 Exhaust the Flexible Duct to the outdoors and fit a one way valve
to prevent rain & dust entering into the Rangehood.

6
Warning: Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
3.2 Fixed to Cupboard.
3.2.1 Drill 6 x 4mm holes into the bottom of the overhead cupboard
according to dimensions shown below. Use the two rear holes if possible,
if not you can use the middle holes in conjunction with the two front
holes.
3.2.2 Fit the plastic outlet to the top of the Rangehood by snapping it into
the hole. Make sure the outlet is fitted all the way around.
3.2.3 Lift the Rangehood and fix into positon with the four 35mm long
screws and washers supplied. Fully tighten the screws.
3.2.4 Fit the rear trim plate to cover any gap between the rear wall and
the rear of the Rangehood with the 13mm self-tapping screws supplied.
3.2.5 Fit the Flexible Duct (not supplied) to the outlet.
3.2.6 Exhaust the Flexible Duct to the outdoors and fit a one way valve
to prevent rain & dust entering into the Rangehood.
Warning: Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
After installation, make sure that the Rangehood is level to avoid
grease collecting at one end.

7
Note: If you do not have an outlet to the outside, you can install the
Rangehood so that it recirculates the air. The installation is the same as
above except that you do not install the flexible duct. For recirculating
installations, we recommend that you fit the activated carbon filters.
Activated carbon filter can be used to trap odors for recirculating
installations.
In order to install the activated carbon filter:
1. Slide out the front section of the Rangehood.
2. Detach the metallic anti-grease filters by pressing the lock and
pulling downwards.
3. To fit the carbon filters, rotate the carbon filter clockwise.
4. To remove the carbon filters, rotate the carbon filter anti-
clockwise.
Ouside the air Recirculates the air

8
•Make sure the filter is securely locked. Otherwise, it could loosen and
cause damage to the unit.
•When activated carbon filter is attached, the suction power will be
reduced.
(4) Safety Warnings
•
••
•This Rangehood is for domestic use only, it is not suitable for
commercial purposes.
•
••
•Please ensure that installation is performed by a qualified
competent installer.
•
••
•This Rangehood and its filter mesh should be cleaned
regularly in order to keep it in good working order.
•
••
•Before cleaning, please switch the power off at the main
supply.
•
••
•Clean this Rangehood according to the instruction manual.
There is a fire risk if cleaning is not carried out in accordance
with the instructions.
•
••
•If there is any fault with the appliance, please switch off
immediately, disconnect and call the service department to
arrange a service.
•
••
•DO NOT flambé under the Rangehood.
•
••
•CAUTION: Accessible parts may become hot when used with
cooking appliances
•
••
•This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.

9
•
•
•
•Children should be supervised to ensure that they do not play
with the appliance. Never let the children operate the
Rangehood.
•
••
•If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
（
（（
（5）
））
） Instructions for Use
Switch on the power to the Rangehood.
5.1 Push switch ① to the “ ” position to switch on the lights,
push switch to the “0” to switch the lights off..
5.2 Push the switch ② to “I” position for low motor speed, push to
“II” for high motor speed. Push switch to “0” to switch the
motor off.
5.3 If switch ② is in either “I” or “II”, the motor will operate
automatically when you pull the front panel forward.

10
(6) Maintenance 
6.1 Cleaning the filters
The filter mesh is made of high-density stainless steel. Please do not
use corrosive detergent on it. Keeping this filter clean will keep the
appliance running correctly. Please strictly follow the guidelines
below.
Method 1: Put the mesh into a sink of clean water, pour on
detergent, and soak for 2-3 minutes. Wear gloves and clean with a
soft brush. Please do not apply too much pressure, as the mesh is
delicate and can be easily damaged.
Method 2: Wash in a dishwasher with the temperature set to around
60 degrees.
6.2 Replacement Light
(1) Switch off the appliance and unplug it.
(2) Slide the front part of the cooker hood.
(3) The metallic anti-grease filter should be detached first.
Press the lock and pull it downward.
(4) Replace with same type of light (max 40W E14).

11
6.3 Cleaning the Rangehood
1. To protect the main body from corrosion, the Rangehood
should be cleaned with hot water plus non corrosive
detergents every two months.
2. Please do not use abrasive detergent because it will damage
the Rangehood.
3. Keep water away from motor and other electrical parts as
this will cause damage to the appliance.
4. Before cleaning the appliance please ensure to shut off the
power and disconnect the plug.
5. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
(7) Troubleshooting
Warning: Service must be performed by an authorised
competent person.
Fault Cause Solution
Light on, but motor
does not work
The flaps are blocked Remove the blockage.
The capacitor is damaged Call for service.
The motor is jammed due to
bearing damage
Call for service.
There is a bad smell coming
from the motor
Call for service.
Light does not work,
motor does not work
Beside the above mentioned, check the following:
Light damaged Call for service.
Power cord not connected Check plugged in and
switched on that power
is available.
Oil leakage
Filters saturated with
cooking oils.
Clean the filters.

12
Leakage between the
connection of U-shaped
section and Rangehood
Remove U-shaped
section and seal
Vibrations The flaps are damaged and
causes shaking
Call for service.
The motor is not fixed
securely to the Rangehood
body
Call for service.
The Rangehood body is not
fixed securely to the wall
Notify your installer.
Insufficient suction The distance between the
Rangehood and the cooking
surface is too much
Notify your installer.
Too much ventilation from
open doors or windows
Close doors or windows,
choose an alternative
location, if possible,
away from draughts.
The Rangehood
inclines
The fixing screws are not
tight enough
Notify your installer.
The hanging screws are not
tight enough
Notify your installer.
Rangehood switched
off during operation.
The safety cut-out device has
activated.
Switch off the
Rangehood and wait for
the device to reset.
If the Rangehood has
been installed below the
minimum heights
indicated in this manual
please notify your
installer.
Eurostyle Group trading as Euro Appliances
Service Line: [phone]
Fax: [phone]
Email: adm[email protected].au