EURO EA60SX User manual

1
Rangehood
Instruction Manual
EA60SX
EA90SX
EP600SWSX
EP900SWSX
EURO APPLIANCES BY EUROSTYLE GROUP

2
CONTENT
1 .............................................. Notice
2 .............................................. Installation Requirements
3 .............................................. Installation – Fitting the Rangehood.
4 .............................................. Safety Warning
5 .............................................. Instructions for Use
6 .............................................. Maintenance
7 .............................................. Troubleshooting

3
(1) Notice
1. Thank you for choosing our Rangehood. Please read this
instruction manual carefully before use.
2. The installation work must be undertaken by a qualified and
competent installer in compliance with applicable Australian
Standards.
3. Euro Appliances disclaims all liability for any damage or
injury caused as a result of not following these instructions for
installation.
This Rangehood is suitable for connection to a 240V, 50Hz
power supply with a proper earth.
Contents
1 x Rangehood
1 x Packet of Screws & Fittings
1 x plastic outlet with flaps
1 x Set of Chimney Pieces (Upper & Lower)
1 x Operating & Installation Instructions

4
(2) Installation - Requirements
Warning: This Rangehood is suitable for indoor installation only in
accordance with the following:
•Installation must be performed by a qualified competent installer.
•If installed above a barbecue, the minimum distance from the
cooking grid/plate is 120cm.
•If installed above a cooking appliance, the minimum distance
from the cooking surface is 65cm.
1. Before installation, please ensure the area is clean to avoid
suction of any debris such as bits of broken wood, sawdust,
etc.
2. Flexible duct bending should be ≥120°.
3. There shall be adequate ventilation of the room when the
Rangehood is used at the same time as appliances burning gas
or other fuels (not applicable to appliances that only discharge
the air back into the room).
4. The air must not be discharged into a flue that is used for
exhausting fumes from appliances burning gas or other fuels
(not applicable to appliances that only discharge the air back
into the room).
5. Regulations concerning the discharge of air have to be
fulfilled.

5
(3). Installation – Fitting the Rangehood.
This Rangehood must be placed at a distance of 65cm minimum from the
cooking surface of a cooker/hotplate and 120cm minimum from the
cooking surface of a BBQ.
3.1 Models without Glass:
3.1 Fit the plastic flaps to the outlet vent of the canopy by deforming
the flaps slightly so that the ends fit into the holes (refer to Pic 3 for
location of the flaps).
3.2 Fit the supplied Hook to the wall using the 36mm long screws
supplied (refer to Pic 1). Fixing method to the wall must be capable of
supporting the weight of the Canopy.
3.3 Lift the Canopy onto the Hook and make sure both left and right
hand hooks are engaged (refer to Pic 1).
3.4 Fit the Flexible Duct (not supplied) to the plastic outlet (refer to Pic
2).
3.5 Exhaust the Flexible Duct to the outdoors and fit a one way valve
to prevent rain & dust entering into the Canopy.
3.6 Determine the height of the U-shaped section. Line up the holes in
the plate with those in the lower U-Shaped section and fix the plate to the
wall using the 36mm long screws supplied (refer to Pic 3 item 1).
3.7 Align the holes in the lower corner of the U-shaped section and fit
the 9mm screw supplied through each side (refer to Pic 3 item 3).
3.8 Pull up the inner U-shaped section to a suitable height and align it
with the upper plate (refer to pic 4).
3.9 Fix the upper plate to the wall using the 36mm long screws. Fix the
inner U-shaped section to the upper plate using two 9mm screws on either
side of the bracket (refer to pic 4).
3.10 Finally, drill two Ø3.5mm holes in line with the 2
nd
plate where the
upper and lower sections overlap. Use a 9mm long screw on each side to
fix them together.

6
Note: Fix the Canopy with two 30mm safety screws. The two safety
screw holes are positioned on the back casing (refer to Pic 5).
Warning: Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
After installation, make sure that the canopy is level to avoid
grease collecting at one end.

7
Note: If you do not have an outlet to the outside, you can install the
Rangehood so that it recirculates the air. The installation is the same as
above except that you do not install the flexible duct. For recirculating
installations, we recommend that you fit the activated carbon filters.
Activated carbon filter can be used to trap odors for recirculating
installations.
In order to install the activated carbon filter, the metallic anti-grease filter
should be detached first. Press the lock and pull it downward.
Plug the activated carbon filter into the unit and turn it in anti-clockwise
direction. Repeat the same on the other side.
•Make sure the filter is securely locked. Otherwise, it could loosen and
cause damage to the unit.
•When activated carbon filter is attached, the suction power will be

8
reduced.
(4) Safety Warning
•
••
•This Rangehood is for domestic use only, it is not suitable for
commercial purposes.
•
••
•Please ensure that installation is performed by a qualified
competent installer.
•
••
•The Rangehood and its filter mesh should be cleaned regularly
in order to keep it in good working order.
•
••
•Before cleaning, please switch the power off at the main
supply.
•
••
•Clean the Rangehood according to the instruction manual.
There is a fire risk if cleaning is not carried out in accordance
with the instructions.
•
••
•If there is any fault with the appliance, please switch off
immediately, disconnect and call the service department to
arrange a service.
•
••
•DO NOT flambé under the Rangehood.
•
••
•CAUTION: Accessible parts may become hot when used with
cooking appliances
•
••
•This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
•
••
•Children should be supervised to ensure that they do not play
with the appliance. Never let the children operate the
Rangehood.
•
••
•If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.

9
（
（（
（5）
））
）Instructions for Use
Switch on the power to the Canopy.
1. Push the low button, the indicating light around the button will
illuminate and the motor runs at low speed. Push it again and
the motor will stop and the light will switch off.
2. Push the middle button, the indicating light around the button
will illuminate and the motor runs at mid speed. Push it again
and the motor will stop and the light will switch off.
3. Push the high button, the indicating light around the button
will illuminate and the motor runs at high speed. Push it again
and the motor will stop and the light will switch off.
4. Push the light button; the indicating light around the button
will illuminate and the two lighting lamps will switch on. Push
it again and the lamps will switch off.
Low Speed Mid Speed High Speed Light

10
(6) Maintenance
6.1 Cleaning the filters
The filter mesh is made of high-density stainless steel. Please do not
use corrosive detergent on it. Keeping this filter clean will keep the
appliance running correctly. Please strictly follow the guidelines
below.
Method 1: Put the mesh into a sink of clean water, pour on
detergent, and soak for 2-3 minutes. Wear gloves and clean with a
soft brush. Please do not apply too much pressure, as the mesh is
delicate and can be easily damaged.
Method 2: Wash in a dishwasher with the temperature set to around
60 degrees.
6.2 Cleaning the Rangehood
1. To protect the main body from corrosion, the Rangehood
should be cleaned with hot water plus non corrosive
detergents every two months.

11
2. Please do not use abrasive detergent because it will damage
the Rangehood.
3. Keep water away from motor and other electrical parts as
this will cause damage to the appliance.
4. Before cleaning the appliance please remember to shut off
the power and disconnect the plug.
5. Do not expose the carbon filter to heat.
6. Please don’t tear open the fixed bar around the carbon filter.
7. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
(7) Troubleshooting
Warning: Service must be performed by an authorised
competent person.
Fault
Cause
Solution
Light on, but motor
does not work
The flaps are blocked Remove the blockage.
The capacitor is damaged Call for service.
The motor is jammed due to
bearing damage Call for service.
There is a bad smell coming
from the motor Call for service.
Light does not work,
motor does not work
Beside the above mentioned, check the following:
Light damaged Call for service.
Power cord not connected Check plugged in and
switched on that power is
available.
Oil leakage Filters saturated with cooking oils. Clean the filters.
Leakage between the
connection of U-shaped
section and Rangehood
Remove U-shaped
section and seal

12
Vibrations The flaps are damaged and
causes shaking Call for service.
The motor is not fixed
securely to the Rangehood
body
Call for service.
The Rangehood body is not
fixed securely to the wall Notify your installer.
Insufficient suction The distance between the
Rangehood and the cooking
surface is too much
Notify your installer.
Too much ventilation from
open doors or windows Close doors or windows, choose an alternative
location, if possible,
away from draughts.
The Rangehood
inclines The fixing screws are not tight enough Notify your installer.
The hanging screws are not
tight enough Notify your installer.
Eurostyle Group trading as Euro Appliances
Service Line: [phone]
Fax: [phone]
Email: adm[email protected].au

13