eyeROBO Adaptica 2WIN User manual

BATTERY CHARGER
USER MANUAL

1
INDEX
Warnings pp. 2-4
Set Up p. 5
Led Information p. 6
Label and Symbol pp. 7-8
Technical Information pp. 9-10
EMC Tables pp. 11-16

2
WARNINGS
READ CAREFULLY THE OPERATING
MANUAL OF 2WIN BEFORE USING
THE BATTERY CHARGER
THIS DEVICE MUST NOT BE USED IN
OXYGEN RICH ENVIRONMENTS OR IN
PRESENCE OF FLAMMABLE PRODUCTS
TO REDUCE THE RISK OF INJURY,
CHARGE ONLY BATTERY MODEL CS-
SP112XL AND PSP-110ML
THIS DEVICE IS DESIGNED TO BE USED
INDOOR. DO NOT EXPOSE TO WATER:
THIS COULD LEAD TO ELECTRIC SHOCK

3
USE ONLY WITH ACCESSORIES
SUPPLIED BY ADAPTICA (USB CABLE,
POWER SUPPLY, ETC.)
NO MODIFICATION OF THIS
EQUIPMENT IS ALLOWED. ONLY
TECHNICIANS AUTHORIZED BY THE
MANUFACTURER MAY SERVICE THE DEVICE

4
The device has been tested and
found to comply to the limits for
medical devices contained in
IEC60601-1-2.
The device may cause radio
interference or may disrupt the
operation of nearby equipment.
It may be necessary to take
mitigation measures, such as re-
orientering or relocating the 2WIN
Battery Charger or shielding the location.

5
SET UP
Insert USB type-C cable
into the charger, and
connect it to power
supply
Insert the battery
inside the charger
Extract the battery and
use it in the 2WIN

6
LED INFORMATION
Red battery light: battery is
charging
Green battery light: battery
is charged
Battery light off: no battery
or damaged battery
Green power light: Power on
Power light off: no power

7
LABEL AND SYMBOLS
Electronic device
subject to the WEEE
Directive on waste
disposal

8
CE Marking
Manufacturer ID
Read user manual
Date of manufacturing

9
TECHNICAL INFORMATION
•AC/DC 110/240 VAC, 50/60 Hz
•Power cable: USB type-C standard cable
•Cable min-max length: 1-1.5 m
•Weight: 70 g
•Battery type: CS-SP112XL and PSP–110ML
•Battery charger size: 6.5 X 7.0 X 2.5 mm
•Rated Voltage: 5 V
•Standard charge: CC-CV method with
charge current of 600 mA

10
•Maximum operating temperature: 25°C
•The battery charger can be attached to
metallic surfaces

11
EMC TABLES
Guidance and manufacturer’s declaration – electromagnetic
emissions
The 2WIN Battery Charger is intended for use in the
electromagnetic environment specified below.
The customer or the user of the 2WIN Battery Charger should
assure that it is used in such an environment.
Emissions
tests
Compliance
Electromagnetic
environment –guidance
RF
emissions
CISPR 11
Group 1
The 2WIN Battery Charger
uses RF energy only for its
internal function. Therefore,
its RF emissions are very low
and are not likely to cause any
interference in nearby
electronic equipment.

12
RF
emissions
CISPR 11
Class B
The 2WIN Battery Charger is
suitable for use in all
establishments, including
domestic establishments and
those directly connected to
the public low voltage power
supply network that supplies
buildings used for domestic
purposes.
Harmonic
emissions
IEC 61000-
3-2
Not applicable
Voltage
fluctuations
/ flicker
emissions
IEC 61000-
3-3
Complies

13
Guidance and manufacturer’s declaration – electromagnetic
immunity
The 2WIN Battery Charger is intended for use in the
electromagnetic environment specified below.
The customer or the user of the 2WIN Battery Charger
should assure that it is used in such an environment.
Immunity test
IEC 60601
test level
Complian
ce
Electromagnetic
environment –
guidance
Electrostatic
discharge
(ESD)
IEC 61000-4-2
±6 kV
contact
±8 kV air
Complies
Floors should be
wood, concrete or
ceramic tile. If
floors are covered
with synthetic
material, the
relative humidity
should be at least
30 %.

14
Electrical fast
transient/burs
t IEC 61000-4-
4
±2 kV for
power
supply lines
±1 kV for
input/outp
our lines
Complies
Mains power
quality should be
that of a typical
commercial or
hospital
environment.
Surge
IEC 61000-4-5
±1 kV
line(s) to
line(s)
±2 kV
line(s) to
earth
Complies
Mains power
quality should be
that of a typical
commercial or
hospital
environment.
Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines IEC
61000-4-11
<5 % UT
(>95 % dip
in UT)
for 0,5
cycle
40 % UT
(60 % dip in
UT)
Complies
Mains power
quality should be
that of a typical
commercial or
hospital
environment. If
the user of the
2WIN Battery

15
for 5 cycles
70 % UT
(30 % dip in
UT)
for 25
cycles
<5 % UT
(>95 % dip
in UT)
for 5 s
Charger requires
continued
operation during
power mains
interruptions, it is
recommended
that the 2WIN
Battery Charger be
powered from an
uninterruptible
power supply or a
battery
Power
frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
3 A/m
Complies
Power frequency
magnetic fields
should be at levels
characteristic of a
typical location in
a typical
commercial or

16
hospital
environment.
NOTE UTis the a.c. mains voltage prior to application of the
test level.

STESK00018_V1_EN
Adaptica Srl
Via San Marco 9/H, 35129 Padova (PD), Italy
[email protected]
www.adaptica.com