FALCON RIDGE CA-X3-WD02 Installation manual

2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Can Am Maverick X3
Full Polycarbonate Windshield
CA-X3-WD02 / 50-40054
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you
are happy with the product before removing protective film. Once the film is removed you cannot return
the product for a full refund.
Be sure to read these instructions thoroughly before opening and installing the Can-Am Full Polycarbonate Windshield.
1. Check over the parts included in the cartons with the parts list shown below:
2” Loom Clamps 6 each
1 1/2” Loom Clamps 2 each
1” Stainless Steels Bolts 8 each
Small SS Washers 8 each
Plastic Thumb Nuts 8 each
Large SS Washers 8 each
Large Rubber Washers 8 each
2” Adhesive Rubber Strips 6 each
56” Small Side Bulb Gasket 1 each
3” Velcro Tabs 2 each
3” Adhesive Hook Strips 2 each
Polycarbonate Windshield 1 each
If any parts are damaged or missing please contact customer service at [phone].
2. Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by peeling off the
protective film. Next take the 56” piece of rubber gasket and starting at one end firmly place across the bottom of the
windshield. You may need to trim off excess gasket. The diagram below show where to install the gasket.
3. Now the Windshield is ready to be installed. With the help of a friend, place the Windshield on the X3, setting it
up onto the hood.

4. Take the remaining hardware and install the windshield to the roll cage as shown in the diagram below.
5. If you have the intrusion bars installed on your X3 you will want to place the adhesive foam strips on the front
edges of the bars where they will come in to contact with the windshield. This is to minimize rattling against the
windshield. See photo below
Thank you for your purchase!

Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under
which your product is covered under our manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the
product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the
problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need
to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.