Fast Mover FMT4400 Specification sheet

T: 44 (0)1582 661993 F: 44 (0)1582 667100 E: [e-mail]
FMT4400
900mm Polymask Dispenser
Product Instrucon Manual
FMT4400_Product Instructions 31/10/2014 07:31 Page 1

FMT4400
Instrucon Manual
Fast Mover Tools Ltd
T: 01582 661993 F: 01582 667100 E: sales fastmovertoolsuk.com
W: www.fastmovertoolsuk.com
Part Description Qty
1 R/H Side Frame 1
2 L/H Side Frame 1
3 Base 1
4 M8 x 45 Bolt 9
5 Cross Tube 1
6 Axle 1
7 Washer 4
8 Wheel 2
9 Snap Pin 2
10 Brake 2
11 M8 Nut 5
12 Spring 1
13 Rubber Spacers 4
14 M8 x50 Bolt 1
15 Washer 13
16 Roll Hub 2
17 Bushing 2
18 Washer 2
19 Pivot Tube 1
20 M8 x 70 Bolt 1
Introduction
The FMT4400 is designed to take a 900mm Roll of Polymask.
General Safety Instructions
1 se this tool on a smooth, level, non-slip surface and always keep your working environment clean and tidy.
2 Do not use this tool whilst under the influence of drugs, alcohol and intoxicating medication.
3 Do not use this tool for any other purpose other than that for which it is intended. This tool is not intended as a
tethering point.
4 Do not allow children and other unauthorised persons to use this equipment.
5 This tool has sharp edges. It is strongly recommended that hand protection is worn when using this tool.
6 Always be aware of those around you and keep in mind that your actions have a direct effect on your colleagues and
visitors.
Parts Diagram
Assembly instructions
Important - Before a embling, note the location of the brake (10), mounting hole in ba e (3) in relation the Cro Tube (5) and
pring (12) mounting hole in the ide frame (1) and (2). A emble a hown in the diagram.
1 Attach Side Frame (1) to the Base (3) label side. se two M8 x 45 Bolts (4). Do not fully tighten.
2 Attach side Frame (2) to the Base with two M8 x 45 Bolts (4). Do not fully tighten.
3 Attach Cross Tube (5) with the label facing out to lower set of holes is Side Frames with two M8 x 45 Bolts. All bolts
can then be tightened.
4 Slide axle through base.
5 Parts should be fitted to the axle in this order: 7, 8, 7 and 9. Wheels should be fitting with ribbed side facing out.
6 Fit two sprung steel brakes (10) to the base using M8 x 45 Bolts and M8 Nuts (11) with the Nut on the upper side of the
frame.
7 Hook guide spring (12) with rubber spacers (13) into the upper holes in side frame.
8 Assemble and instal roll hubs as shown.
FMT4400_Product Instructions 31/10/2014 07:31 Page 2