Fastway ONESTEP XL Manual

STABILIZING WHEEL CHOCK
ONESTEPxl
™
Instructions for Setup and Use
1. Remove the Fastway® ONESTEP™ chock and other parts
from the packaging. Remove the bolt and nut holding the
double arms to the wedge using the hex key provided for
adjustments, and a 9/16” socket. See Figure 1.
2. Using the same nut and bolt, install the extra single arm
onto that same wedge. The bolt should go through the end
of the arm with the single hole. See Figure 2.
3. Set the chock between the tires and extend the arms out
until the wedges touch the tires. See Steps 3 - 5 in the
standard instructions.
4. Temporarily place the second clevis pin into the hole that
aligns best between the double and single arms. Do not
put the retainer clip into place on the pin yet.
5. Slide the chocks out from the tires. Remove the clevis pin,
slide the chock arms apart one hole, then replace the pin.
Secure the pin with the clip.
6. Place the chock between the tires again. It should fit
snuggly between the tires, with the center arms not
dropping all the way to the ground. Step down on the
center arms to lock the chock into place. Pull up on the
cable handle to remove the chock. See Figure 3.
7. Re-adjust the chock as necessary by moving the clevis pin
to different holes, or by moving the end bolts that attach
the arms to the wedges to a different hole.
For a video demonstration of the chock visit our YouTube
channel: youtube.com/fastwaytrailer.
Figure 3
Figure 2
Figure 1
Fastway ONESTEP - Faster, Easier.™

The Fastway ONESTEP chock was designed to be used on level ground and gentle slopes. Do not use the
chock on grades that are excessive or unreasonably steep. Always remember to remove the chock before
towing the trailer. Damage caused by driving over the wheel chock is not covered by the warranty.
WARNING
A product of Progress Mfg. Inc.
353 South 1100 West
Provo, UT 84601
877-523-9103
fastwaytrailer.com Copyright 2018 Progress Mfg. inc., all rights reserved. Patent No. 8,499,899 FWOS0318
Limited one year warranty
Progress Mfg. Inc. warrants, to the original purchaser, this product against defects in materials and
workmanship for a period of one year from date of purchase. This warranty does not cover damage due
to normal wear and tear, misuse, neglect, abuse, or product finish. Progress Mfg. Inc. reserves the right to
repair or replace the defective part(s) at their discretion. Replacement of product or refund constitutes the
fulfillment of all liabilities of Progress Mfg. Inc. under this warranty. For questions about warranty coverage
and warranty authorization, please call 877-523-9103. If warranty repair or replacement is approved, send
the entire product and proof of purchase, shipping pre-paid, to: Progress Mfg. Inc., 353 South 1100 West,
Provo, UT 84601.
Submit your warranty registration online at fastwaytrailer.com.