Fellowes AERAMAX PRO AM3 User manual

AERAMAX®PRO AM3
AM3S
Quick
Start
Guide

This guide is for machine set-up. For full installation guidelines, please refer to the product
documentation that came with the unit, or visit http://support.fellowes.com

AeraMax AM3 | 3
Welcome to
Healthy Air

4 | Setting Up
01
»Open unit fully by pressing latches on both sides.
02
»If locked, insert key and rotate counterclockwise ¼.
Setting up your air purifier

3
2
1
4
AeraMax AM3 | 5
03
»Remove all lters from plastic. Check that the Velcro on
the carbon lter is facing out. Attach pre-lter to the Velcro
strips in each corner of the carbon lter.
04
»Arrange lters in proper order. HEPA is placed rst in the
frame. Carbon on top of HEPA. Pre-lter on top of Carbon,
attached in all four corners.

OR
6 | Setting Up
05
»Place lter assembly back into unit. White sticker on top
and white pre-lter in front.
06
»Close front panel until you hear a click.

AeraMax AM3 | 7
07
FLOOR UNITS ONLY: Plug into an outlet and ensure the
power switch located at the bottom rear of the unit next to
the power cord is switched to the on position. The unit
will now be in auto-mode.
08
»Once the oor or wall unit is powered up, open front panel
to adjust settings.
Getting started

8 | Getting Started
11
»PlasmaTrue™ will be o by default. Turn the ionizer on
by pressing and holding the ionizer icon until it is illuminated.
09
»There are two settings, normal and quiet mode. Unit is
defaulted to normal.
10
»To select quiet mode, hold down the fan icon on the
right for a few seconds until you hear a beep and the icon
is illuminated.
12
»Close the front panel.

AeraMax AM3 | 9
13
»Once settings are complete, insert key on the right side and
rotate clockwise ¼ turn to lock machine.

10 | Setting Up