10
Sensor lights upTouch test areaPress Auto-On ( )
ENGLISH
Model DS-3
2
— To Test SafeSense
®
Technology
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
CAPABILITIES
Breakthrough Safety Technology! SafeSense®stops shredding when hands are too close to the opening.
• Keepawayfromchildrenandpets.Keephandsawayfrompaper
entry. Always unplug when not in use.
• Keepforeignobjects–gloves,jewelry,clothing,hair,etc.–away
fromshredderopenings.Ifobjectenterstopopening,pressand
holdReverse(R)tobackoutobject.
• Neveruseaerosol,petroleum-basedorotherflammableproductsonor
near shredder. Do not use canned air on shredder.
• Donotuseifdamagedordefective.Donotopenshredderhead.
Donotplacenearoroverheatorwatersource.
• 10sheetsperpasstoavoidjams.
• AvoidtouchingexposedbladesunderCross-Cutshredderhead. • Thesocket-outletshallbeinstalledneartheequipmentandshallbeeasily
accessible.
Will shred:Paper,smallpaperclips,creditcardsandstaples
Will not shred:Continuousforms,adhesivelabels,transparencies,newspaper,
cardboard,largepaperclips,laminatesorplasticotherthan
notedabove
Paper shred size:
Cross-Cut......................................................................... 5/32”x2”(3.9x50mm)
Maximum:
Sheetsperpass(Cross-Cut).................................................................................10*
Cardsperpass....................................................................................................... 1
Passes per day ............................................................................................... 10-20
Paper width............................................................................................9”/229mm
Continuousoperation............................................................................. 4-5minutes
*20lb.,8.5”x11”paperat120v,60Hz,3.8Amps;heavierpaper,humidityorotherthan
ratedvoltagemayreducecapacity.
Fellowes SafeSense®shreddersaredesignedtobeoperatedinhomeandoffice
environmentsrangingbetween50–80degreesFahrenheit(10–26degreesCelsius)and40
–80%relativehumidity.
SET-UP
Placeheadonbasket
as shown:
Disconnect power switch
mustbeinON(I)
position to operate
shredder.
Waste opening
Overheated(red)
Controlswitch
SafeSense
®
Technology (yellow)
Standby(green)
Shredder head
Paper entry
Auto-On ( )
Off
Reverse(R)
Basket
Grips
Bin full indicator
Safe Sense
®
overrideswitch
Disconnect power switch
Handle
Seesafetyinstructionsbelow
Active NotActive
Set to Off
Feed into paper entry
and release
Set to Off
LIMITEDWARRANTYFellowes,Inc.(“Fellowes”)warrantsthecuttingbladesofthemachinetobefreefrom
defectsin materialand workmanshipfor 3 yearsfrom thedate of purchaseby theoriginal consumer.
Felloweswarrantsallotherpartsofthemachinetobefreeofdefectsinmaterialandworkmanshipfor1
yearfromthedateofpurchasebytheoriginalconsumer.Ifanypartisfoundtobedefectiveduringthe
warrantyperiod,yoursole and exclusiveremedywillberepair or replacement,atFellowes’optionand
expense,ofthedefectivepart.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY,INCLUDINGTHATOFMERCHANTABILITYORFITNESSFORAPARTICULARPURPOSE,ISHEREBY
LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall
Fellowesbeliableforanyconsequentialorincidentaldamagesattributabletothisproduct.
Thiswarrantygivesyouspecificlegalrights.Theduration,terms,andconditionsofthiswarrantyarevalid
worldwide,exceptwheredifferentlimitations,restrictions,orconditionsmayberequiredbylocallaw.
Formoredetailsortoobtainserviceunderthiswarranty,pleasecontactusoryourdealer.
Gently pull uncut paper
frompaperentry.Plugin.
Press and hold
Reverse(R)
2-3 seconds
Set to Off (O)
and unplug
Runregularlyinreversefor
oneminute
Oilwhenbinisfull,or
immediately,if:
• Capacitydecreases
• Motorsoundsdifferent,or
Shredder stops running
OPERATION
TROUBLESHOOTING
MAINTENANCE
3
Shredder doesn’t start:
Followoilingprocedurebelowandrepeattwice.
WARRANTY
Alternateslowlybackandforth
*Apply oil
across entry
Press and hold
Reverse(R)
2-3 seconds
Shred one sheet
Set to Off
Press Auto-On ( )
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
notactive
Makesureheadisonbasketcorrectly
Wait20minutesformotortocooldown
Removeandemptybasket
Press Auto-On ( )
Paper jam: SettoOff(O),removeshredderheadandemptybin.Replaceshredderhead,andfollowanyorallofthe
belowprocedures.
PAPER
CARD
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
ATTENTION: If the SafeSense®lightremainson,youmustengagethe Override Switchinordertoperformstepsabove.Oncethejamiscleared,resetthe
SafeSense®feature. (See SafeSense®instructionsbelow.)
SafeSense®overrideswitch
Active Notactive
Sensorlightilluminated–paper
jammed
SafeSense®paper jam: If the SafeSense®featureactivates(SafeSense®lightremainson)tocausetheuser
tothinktheshredderhasjammedwhenithasnot,usetheOverride SwitchtodeactivatetheSafeSense®
feature and clear the paper. Warning–whenswitchisinoverrideposition,theSafeSense®light will flash and
the SafeSense®feature will NOT function. Once the paper is cleared, reset the SafeSense®feature.
Feed into paper entry
and release
Press Auto-On ( )
Continuous operation:
4-5-minutemaximum
NOTE:Shredderrunsbriefly
after each pass to clear entry.
Continuousoperationbeyond
4-5-minuteswilltrigger
20-minutecooldownperiod.
Press and hold
Reverse(R)
