felton industries FELIGPS User manual

WARNING: READ THE ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING THE IN GROUND PARK SETTING.
Make sure to wear protecve gloves and foot protecon when installing and assembling this product. Unpack the unit and make sure all the components are
included before proceeding. This acvity requires two o more people as liing is involved. Please ensure all bolts are only nger-ghtened during the assembling
process for exibility in lining up components. Securely ghten all bolts before anchoring the product to the ground.
Thank you for purchasing our high quality products. The In Ground Park Seng has been manufactured with cered materials, to achieve high reliability and minimum maintenance. It is our
commitment to provide you cost eecve soluons for outdoor applicaons.
IGP2
ITEM DESCRIPTION QTY
IGP1 TABLE FRAME 2
IGP2 SEAT FRAME 4
IGP3 TABLE / SEAT PLANK—1800 mm. 5
IGP4 M6x25 mm. HEXAGONAL HEAD BOLT 40
IGP5 M6 LOCKNUT 40
IN GROUND PARK SETTING
(CODE No. FELIGPS)
IGP1 IGP3 IGP5
IGP4
1
2
A. Place the 3 table planks (IGP3) up side down on a at
surface and aached them to the table frames (IGP1), by
using hexagonal head bolts (IGP4) and locknuts (IGP5) —
nger ghten.
B. Adjust all bolts properly with a span, wrench and/or any
appropriate tool.
A. Place a seat plank (IGP3) on a at surface and
aached them to the seat frames (IGPS1), by using
hexagonal head bolts (IGP4) and locknuts (IGP5) —
nger ghten.
B. Repeat the same process to assemble the two in
ground seat park sengs.
C. Adjust all bolts properly, by using span, wrench and/
or any appropriate tool.
[IGP4 x 4]
[IGP5 x 4]
[IGP4 x 4]
[IGP5 x 4]
[IGP2]
[IGP2]
[IGP3]
[IGP1]
[IGP1]
[IGP3]
P1

WARNING: READ THE ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING THE IN GROUND PARK SETTING.
Make sure to wear protecve gloves and foot protecon when installing and assembling this product. Unpack the unit and make sure all the components are
included before proceeding. This acvity requires two o more people as liing is involved. Please ensure bolts are only nger-ghtened during the assembling
process for exibility in lining up components. Securely ghten all bolts before anchoring the product to the ground.
GENERAL INSTALLATION RECOMMEDATIONS:
A. Turn the enre assembly upright and mark the locaon of the leg supports, according to the illustraon above.
B. Prepare the leg foundaon as necessary. Install both, table and seat legs accordingly.
C. We recommend to place at minimum 300 mm. of the seat legs in concrete.
D. We also recommend to place at minimum 600 mm. of the table legs in concrete.
3
P2