Fiilex C365 User manual

Safety Instructions
User Guide
Parts Diagram
• DO NOT look into the light source. Be cautious of the high-intensity beam.
• DO NOT disassemble C360/C365. This will void the warranty.
• DO NOT install C360/C365 in damp or wet locations.
• DO NOT install C360/C365 less than 6 inches from any curtains or combustible materials.
• DO NOT obstruct the fixture’s air vents.
• Use safety cable (not included) when rigging C360/C365 overhead.
• Make sure to follow local building codes when installing C360/C365.
• Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
C360 / C365
1. Power Cord
2. Power Module Box
3. Size M12 Screw Receiver
4. Side Vents
5. Barndoor Lock
6. Yoke Knob
7. Magnetic Accessory Lock
8. Barndoor Slot
9. 5” Fresnel Zoom Lens (C365 only)
10. Lens Tighten Knob (C365 only)
11. Barndoor Lock (C365 only)
12. Barndoor Slot (C365 only)
13. Barndoor Lock Release
14. Yoke
15. CCT / HUE Knob
16. On / Off Button
17. RJ45 In / Out
18. OLED Display
19. Intensity / DMX Knob
20. Rear Vents
10
912
11
13
14
16
17
18
19
20
15
1
2
5
6
7
8
43
210224A

Indicator Light
Fixture Settings
Intensity
CCT
HUE (Magenta/Green)
Turn the Intensity Knob (19) to adjust brightness.
Turn the CCT Knob (15) to adjust color temperature.
Double click the HUE Knob (15) to access HUE setting.
Double click the DMX Knob (19) to set a DMX address (Range: 1 - 510).
When a DMX address is selected, the fixture will automatically assign the next addresses
in the following order: 1. Intensity 2. CCT 3. HUE
DMX Control
Mode
Fixture is off and receiving power.
Light settings can be adjusted via manual control knobs.
Fixture is receiving DMX control signal.
Manual control knobs are disabled while DMX is active.
Fixture is on.
On/Off Buttom (15) Description
Manual Contol
Manual Contol
DMX Control
Red
Green
Orange
1689 Regatta Blvd. Richmond, CA 94804 | [phone] | [e-mail] www.fiilex.com