Fiilex P360 Gen II Series User manual

P360 Gen II Series
Portable LED Light
User Manual

What’s in the Box
Light Components
Setup and Basic Operation
Optional Accessories
Specifications
For Your Safety
1
2
4
6
8
9
Table of Contents

1
What’s in the Box
• 4 Leaf Barndoor Set• P360 Classic / Pro / Pro Plus
• Power Adapter

2 3
Light Components
C
D
E
F
O
P
G
H
I
J
K
L
M
N
4 Leaf Barndoor
Barndoor Brackets
Accessory Lock
Side Vents
Yoke Knobs
Rear Vents
Light Intensity / DMX Address Knob (DMX: P360 Pro /
P360 Pro Plus Only)
Light Control Output Jack (P360 Pro / P360 Pro Plus Only)
DC Power Input Jack
On / Off Button
CCT / Hue Tuning Knob (Hue: P360 Pro Plus Only)
Light Control Input Jack (P360 Pro / P360 Pro Plus Only)
Yoke
Light Stand Adapter
OLED Display (P360 Pro / P360 Pro Plus Only)
Accessory Lock Release
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P

54
Setup and Basic Operation
Initial Setup
1. Mount Light Stand Adapter (O) to 5/8” Stud on light stand.
2. Slide Barndoors into Barndoor Brackets (B) until Accessory
Lock (C) clicks.
To release Barndoors, slide back Accessory Lock Release (Q) and
slide Barndoors out of Barndoor Brackets (B).
3. Insert DC power plug from power adapter into DC Power
Input Jack (I).
4. Connect Power Adapter to AC Power.
5. Press On/Off Button (J) to activate light.
Light Settings
Turn CCT Tuning Knob (K) to adjust color temperature
(2800-6500K).
Turn Intensity Knob (G) to adjust light intensity (0-100%).
(Pro Plus only) Double click CCT / Hue Tuning Knob (K) to
enter hue tuning mode, then turn knob to adjust hue
(±0.25 green). To return to CCT tuning mode, click knob
(K) again or wait 3 seconds.
DMX (Pro / Pro Plus only)
1. Insert phone jack (TRRS) connector into LIght Control
Input / Output Jack (H/L).
2. Double click Intensity / DMX Address Knob (G) to enter
DMX address edit mode, then turn knob to select address.
To return to intensity adjustment mode, click knob (G)
again or wait 3 seconds.
DMX connection requires three-ring TRRS phone jack.
Cable Adapter accessories are available to facilitate DMX
connection via RJ45 and XLR.

7
For additional accessories go to www.fiilex.com
Optional Accessories
6
D-tap Cable Softbox
Dome DiffuserFresnel Lens Power Adapter Holder
XLR Unit Link Adapter
DMX Controller
RJ45 Unit Link Adapter
with RJ45 Coupler

8
Specifications
Size (without Barndoor)
4” x 4.7” / 102mm x 119mm
Weight (Includes Yoke)
1.6 lb / 0.74 kg
LED
Dense Matrix LED
Thermal Design
Advanced Cooling System
CCT Range
2800-6500K Continuous Tuning
Hue Range (Pro Plus only)
-0.25 to +0.25
CRI
>93
Power Consumption
90W Max.
Power Input
12 to 30 V DC
AC Adapter
100-240VAC, 50/60Hz (In) / 24V DC,90Wmax.(Out)
Operating Temperature
0º to 40ºC / 32º to 104º F
IP Rating
IP-24

9
Information and Specifications in this document are subject to change without notice. DiCon
Lighting, Inc. assumes no responsibility or liability for any error or inaccuracies that may
appear in this manual. Unlawful reproduction or distribution in any manner without the
written permission of DiCon Lighting, is strictly prohibited.
© DiCon Lighting 1996-2017 All Rights Reserved
Fiilex.com
1689 Regatta Blvd. Richmond, CA 94804
[phone] . [e-mail]
For Your Safety
• Do not attempt to disassemble the body of the P360,
doing so will immediately void the factory warranty.
• Do not install the P360 in a damp or wet area.
• Do not submerge P360 in water.
• Do not cover the side or back air vents.
• Only use the included power adapter, failure to do so
may cause damage to the LED light.
• Only use a soft, dry towel to gently clean the exterior
of the light.
• Before using the light for the first time, remove the
protective membranes.

Fiilex.com
3
4 Leaf Barndoor
Barndoor Brackets
Accessory Lock
Side Vents
Yoke Knobs
Rear Vents
Light Intensity / DMX Address Knob (DMX: P360 Pro /
P360 Pro Plus Only)
Light Control Output Jack (P360 Pro / P360 Pro Plus Only)
DC Power Input Jack
On / Off Button
CCT / Hue Tuning Knob (Hue: P360 Pro Plus Only)
Light Control Input Jack (P360 Pro / P360 Pro Plus Only)
Yoke
Light Stand Adapter
OLED Display (P360 Pro / P360 Pro Plus Only)
Accessory Lock Release
Ver.A1