
Page 2
Tip Chart
Speed Chart
the trailer frame.
best as possible.
wheel in place.
hardware to secure the boom in place.
or the "hot" connection on a switch or to the ammeter. The
brown wire may be grounded or connected to the negative
thread it onto the drain bung located at the lower rear end
handgun storage.
Read the operating instructions and then run the sprayer
using only water for testing. Initially begin spraying by clos
valve to the boom. This will enable the air in the line to be
eliminated through the tips, while building pressure. When
the spraying operation.
OPERATION
This sprayer is designed to be towed behind a garden
tractor.
NOTE: Make sure the tires are inated to 30 P.S.I. prior
to usage!
the strainer and to the pump. The pump forces the solution
under pressure to the handgun or boom nozzles.
The pump has a pressure switch which will shut the pump
vary when turning the nozzle end.
concrete surface. Raise the boom to get more spray pattern
overlap if desired.
WARNING: Some chemicals will damage the pump valves if
manufacturers instructions on disposal of all waste water
from the sprayer.
CALIBRATION
Chemical labels may show application rates in gallons per
feet. You will note that the tip chart shows all three of these
rating systems.
PRESSURE SWITCH OPERATION
Pressure switch is pre-set at the factory. Improper
adjustment of the pressure switch, may cause severe overload or
premature failure. If the pump is subjected to rapid cycling during
normal operation, or infrequent periods, damage may occur.
CAUTION