Finger Access FA88 User manual

Functions/Operation
Opening operation
Directly input 6 digits of a correct pin code already stored. If
the pin code is correct the green light will turn on. Open the
door within 5 seconds.
Add pin codes
Press: ## + master pin code + #**+ user ID number (3digits)
+ new pin code (6digits) + new pin code.
User Id is a 3 digit number between 001-199.
User pin code can be any 6 digit number.
Example: Using the master pin code of “111111” and entering
user Id 005 with a pin code of 123456 the operation would be
like this:
Press: ## + 111111 + #** + 005 + 123456 + 123456
Change pin codes (master pin code and user pin code)
Press ## + pin code being changed + *** + new pin code +
new pin code
Delete pin codes (master pin code cannot be deleted)
Press: ## + master pin code + *#* + user Id + user Id
Turn on the 1 key opening function
Press: ## + master pin code + ### + ###
Cancel the 1 key opening function
Press: ## + master pin code + ### + ###
Finger Access Pty Ltd
Wwww.fingeraccess.com.au
Finger Access Pty Ltd
Wwww.fingeraccess.com.au
FA88 Pin Code Door Lock
User Manual
Read this manual carefully before operating your pin code lock
Product Introduction
Important note: Original master pin code “111111”. Please
change the master pin code when you use the lock for the first
time. Each pin code must be 6 digits.
‐The pin code lock can save 200 sets of pin codes.
‐Master pin code is the management pin code with the
highest authority. Through the master pin code you can
add user settings and change door lock functions.
‐When you hear “di di di di di di” six warning tones from
the pin code lock, please change the batteries in time.
‐There is a reset switch at the rear of the lock body. Press
this switch to restore the master pin code to “111111”. If
you press this switch continuously for more than 2
seconds, they pin code lock will be restored to the original
factory settings, that is restoring the master pin code to
“111111” and clearing all sub-pin codes.