Firecom LW-10 User manual

Model LW-10
Light weight,
Radio-Transmit Headset
with Glove Rugged™Plug
and In-Line Control Box
Part Number: 105-0140-00
Two-Year Limited Warranty to the Original Purchaser
Sonetics Corporation warrants to the original purchaser of its products, that they will be free from defects
in materials and workmanship, under normal and proper use, for the period of two years from date of
purchase. Sonetics Corporation will repair or replace, at its option, any parts showing factory defects
during this warranty period, subject to the following provisions. This warranty applies only to a new product
which has been sold through authorized channels of distribution. All work under warranty must be
performed by Sonetics Corporation. All returned products must be shipped to our address, freight
prepaid, accompanied by a dated proof of purchase. The purchaser voids this warranty if he, she or
others attempt to repair, service or alter the product in any way. This warranty does not apply in the event
of accident, abuse, improper installation, unauthorized repair, tampering, modification, fire, flood,
collision, or other damage from external sources, including damage which is caused by user replaceable
parts (leaking batteries, etc.). This warranty does not extend to any other equipment or apparatus to
which this product may be attached or connected. The foregoing is your sole remedy for failure in
service or defects. Sonetics Corporation shall not be liable under this or any implied warranty for
incidental or consequential damages, nor for any installation or removal costs or other service fees.
This warranty is in lieu of all other warranties, express or implied, including the warranty of
merchantability or fitness of use, which are hereby excluded. To the extent that this exclusion is not
legally enforceable, the duration of such implied warranties shall be limited to two years from date of
purchase. No suit for breach of express or implied warranty may be brought after two years from date
of purchase.
FIRECOM is a division of Sonetics Corporation
7340 SW Durham Road •Portland, Oregon 97224
800-527-0555 •503-684-6647 •Fax: [phone]
Email: [email protected] •www.firecom.com
Copyright © 2004 Sonetics Corporation - All rights reserved.
The information in this document is subject to change without notice.
No part of this document may be reproduced in any form without prior written consent of Sonetics Corporation.
This document is part number 600-0140-00 Printed in U.S.A.
Features
•Behind-the-head, ultralight headband
•In-Line control box with belt clip
•Detent volume control located on the control box
•Push-To-Talk (PTT) located on the control box
•Flexible mic boom for accurate mic positioning
•Coiled cord which extends up to 6 feet
•Designed for listening to all radio and intercom communication
•Capable of transmitting on the intercom and on the radio
•Two-year warranty

Proper Fit
The headband is to be worn behind the head with the speaker located on the left ear.
Microphone Placement
Place the microphone in front of the mouth and NO MORE than 1/8"away from the lips as
shown in the diagram below. Placement of the microphone is CRITICAL for proper operation.
If the microphone is positioned incorrectly, you may experience a reduction in
volume and clarity of intercom and radio communication.
Headset Volume
Turn the intercom volume down. Preset each headset volume to the highest setting (full clock-
wise). Set the intercom volume to a level above the normal comfortable listening level, but at a
level which does not cause distortion. Reset the individual headset volume for best listening level.
Intercom Communication
The headset microphone is always active for intercom communication. Simply speak into the
microphone to be heard over the intercom.
Radio Transmit
The LW-10 headset has a Push-To-Talk (PTT) button on the in-line control box.. Pressing this
button will key the radio. Press and hold the PTT while speaking into the microphone to
transmit on the radio.
Mic Muffs
The headset microphone is covered with a replaceable foam mic muff. This mic muff helps
prevent the “pops” and “hisses” that can occur from speaking into a microphone that is close
to the mouth.
Replacement Parts & Accessories
Description Part Number
Mic Muffs, (Qty5) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 108-0004-60
Clothing Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 108-0057-00
Ear Pad . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 108-0061-00
Temple Pad . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 108-0062-00
Specifications
Headset
Performance . . . . . . . . . . . . . . 90 dB with AVG SPL (300=3KHz) @ .387 VRMS input
Frequency Response . . . . . . . . . . . . . . . . . . . . 100-17,000 Hz +5 dB in 6 cc coupler
Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .150 ohm@1KHz
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.69 oz.
Microphone
DC Bias Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-16 volts, not polarity sensitive
Source Resistance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 220 to 2200 ohms
Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40 dB Typ@94 DB SPL
Frequency Response . . . . . . . . . . . . . Optimized for speech clarity and noise reduction
Headband worn
behind the head
Push-To-Talk (PTT) button
Volume control
No more than
1/8" from lips