Fisher & Paykel OR90SCG1X1 User manual

Cooktop Use
Using Your Gas Cooktop
1. Rapid burner
2. Semi-rapid burner
3. ok burner
4. Auxiliary burner
Control Dials
The dials control the flow of gas through the valve.
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SCG1X1/User_Guide_OR90SCG1X1/0…
Updated: ed, 12 Apr 2023 02:58:47 GMT
Powered by
1

1. Identify the dial of the burner you want to use.
2. From the 0(OFF) position push the dial in and turn it anticlockwise to HI.
◦ The ignitors on all the burners will spark.
3. After the burner has lit keep the dial held in for a few more seconds before releasing.
◦ Releasing the dial too soon will extinguish the flame.
4. hen the burner has lit, adjust the flame
anywhere between HI and LO.
• Do not adjust the dial between HI and
O(OFF)
5. hen you have finished cooking, turn the dial clockwise back
to O(OFF).
• If you are using LP gas, there may be a slight ‘extinction
pop’ or flash at the flame spreader a few seconds after
the burner has been turned off. This is normal for LP gas.
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SCG1X1/User_Guide_OR90SCG1X1/0…
Updated: ed, 12 Apr 2023 02:58:47 GMT
Powered by
2

Flame Failure Protection
Your cooktop is equipped with flame failure protection: the gas supply will automatically be cut off to a burner that is
accidentally blown out by a draught or extinguished by a spill.
If a Burner does not Light
Turn the control dial to O(Off) and wait at least one minute before trying again, to all the gas to disperse.
If the burner still does not light, check that:
• The cooker is plugged in and the power supply is switched on
• There is no power failure in your home or neighborhood
• The gas is turned on
• The gas bottle is not empty (if you use bottled gas)
• The ignitors are sparking. If they are not sparking, they may be dirty or wet. Clean them with a toothbrush and
methylated spirits, as shown below. See ‘Care and cleaning’ for instructions on removing and replacing the
burner parts.
Cleaning the Probe & Ignitor
If the Flame is Irregular
Check that the burner parts (flame spreader and burner cap) are:
• Clean and dry
• Positioned correctly, as shown below.
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SCG1X1/User_Guide_OR90SCG1X1/0…
Updated: ed, 12 Apr 2023 02:58:47 GMT
Powered by
3

• For further advice, see sections ‘Care and cleaning’ and ‘Troubleshooting’.
Burner parts Correct assembly of burner parts
Incorrect assembly of burner parts,
resulting in irregular flames
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SCG1X1/User_Guide_OR90SCG1X1/0…
Updated: ed, 12 Apr 2023 02:58:47 GMT
Powered by
4