Fisher-Price 79339 User manual

Please save these instructions for future reference.
Adult assembly is required.
Requires one size “D” (LR20) alkaline battery (not included).
Deluxe
Soothing Bouncer Seat
Model Numbers: 79339, 79346, 79380
®
To prevent serious injury and/or falls:
• Never use on any elevated surface.
• Never use as a carrier or lift while child is seated.
• Always use the restraint system.
• Never leave child unattended.
• Never use as a car seat.
• Never use with a child able to sit upright, unassisted.
WARNING

• Place the base tube on a flat surface as shown.
• Position the left and right base wires as shown.
• Insert the left base wire into the base tube, until the red
mark on the left base wire is covered by the base tube.
• Insert the right base wire into the base tube, until the red
mark on the right base wire is covered by the base tube.
Base Tube
Red
Mark Red
Mark
Right Base Wire Left Base Wire
1
Fisher-Price
OFF ON
Fisher-Price
®
Right Base Wire
Pad with
Canopy
Left Base Wire
Base Tube
Footrest Wire
with Soothing Unit
Seat Back Wire
Thank you for purchasing the Fisher-Price®Deluxe Soothing
Bouncer Seat. The Deluxe Soothing Bouncer Seat requires
adult assembly. Please read these instructions thoroughly
and identify all parts before assembly.
Occasionally a consumer may experience a problem with
one of our products. If this should happen please call us,
toll-free, rather than return this product to the store.
Usually, we can solve the problem over the telephone or
send you replacement parts. Please call Fisher-Price®
Consumer Affairs, toll-free at 1-800-432-KIDS, between
8 AM - 5 PM EST, Monday through Friday. Hearing-impaired
consumers using TTY/TDD equipment, please call
1-800-382-7470. Or write to: Fisher-Price®Consumer Affairs,
636 Girard Avenue, East Aurora, New York 14052.
Toy Bar
MirrorRings Paddle
Paddle
Message to Parents
Assembly
Parts
2
-
+
SHOWN ACTUAL SIZE
1.5V
“D” (LR20)
Requires one size “D” (LR20) alkaline battery
(not included).

OFF ON
OFF
• Position the seat back wire above the ends of the left and
right base wires as shown. Make sure the seat back
wire bends backward.
• Fit one end of the seat back wire onto the left base wire,
until the red mark on the left base wire is covered by the
seat back wire.
• Position the footrest wire with soothing unit upright.
• Hook the footrest wire with soothing unit onto the ends
of the left and right base wires.
Seat Back Wire
Footrest Wire
with Soothing Unit
Left Base Wire
Red
Mark
Red Mark
Right
Base
Wire
Left
Base
Wire
Assembly
3
• Turn the Deluxe Soothing Bouncer Seat frame on its side
with the unconnected seat back and right base wires up,
as shown.
• Push down on the unconnected seat back wire and fit it
onto the right base wire, until the red mark on the right
base wire is covered by the seat back wire.
• Turn the Deluxe Soothing Bouncer Seat frame upright.
Make sure the seat back wire is securely attached to
the left and right base wires.
Seat Back Wire
Right Base Wire
2
3
4
OFF ON
®
Fisher-Price
®
• Position the pad so that the cut-out is toward the
soothing unit.
• Locate the large upper pocket on the back of the pad.
• Slide the pad pocket over the seat back wire. Do not fit
the pad over the toy bar sockets.
Helpful Hint: Before assembling the lower portion of the
pad to the footrest wire with soothing unit, you may want
to install the battery in the soothing unit. Please see the
next section (page 5, Battery Installation) for instructions.
Pad
Soothing
Unit
Cut-out
Toy Bar
Socket
Toy Bar
Socket
5

• Snap the mirror and the paddles to the toy bar.
• The rings can be attached to the mirror and one of the
paddles, as shown.
Helpful Hint: Twist the ends of the rings apart to attach
them to the mirror or paddle.
• The toy bar is removable. Simply pull out near each toy
bar plug to remove the toy bar.
Assembly is now complete.
Mirror
Paddle
Ring
9
OFF ON
Fisher-Price
®
• Lift the front of the pad to locate the small lower pocket.
• Lift the footrest wire with soothing unit.
• Fit the pad pocket over the footrest wire with
soothing unit.
• Fit the small openings on each side of the pad over the
toy bar sockets.
• Lower the footrest wire with soothing unit.
Footrest Wire
with Soothing Unit
• Spread the toy bar ends outward to fit the plugs into the
toy bar sockets.
Helpful Hint: The toy bar plugs are different sizes and
must be inserted into the proper toy bar socket. If the toy
bar plugs do not fit, turn the toy bar around.
Toy Bar
Socket
Toy Bar
Plug
Toy Bar
Socket
Toy Bar
Plug
Small
Lower
Pocket
Toy Bar
Socket Wire Loops
Toy Bar
Socket
13"
• Periodically check to be sure the toy bar plugs are
approximately 13 inches apart. After several attach-
ments the toy bar plugs may spread further apart.
• If the toy bar plugs spread apart more than 13 inches,
grasp the toy bar with both hands near one of the top
corners. Bend the arm inward slightly.
• Grasp the toy bar with both hands near the other top
corner. Bend the arm inward slightly.
• Measure the distance between the toy bar plugs to
see if it is approximately 13 inches. If it is shorter or
longer, adjust the toy bar until the toy bar plugs are
approximately 13 inches apart.
Toy Bar Plug
Top Corner
Top Corner
Arm
Arm
Toy Bar Plug
Assembly
4
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.
©1999 Mattel, Inc. All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel, Inc.
Printed in Hong Kong 79339F - 0920
68
7

Use
To prevent serious injury and/or falls:
• Never use on any elevated surface.
• Never use as a carrier or lift while child
is seated.
• Never leave a child unattended.
• Never use as a car seat.
WARNING
OFF ON
®
• If the toy bar is attached, remove it before placing your
child in the Deluxe Soothing Bouncer Seat.
• Place your child in the Deluxe Soothing Bouncer Seat.
Position the restraint between your child’s legs.
• Fasten both belts to the buckles on each side of the
restraint. Make sure you hear a “click” on both sides.
• Make sure the restraint is securely attached by pul-
ling it away from your child. The restraint should
remain attached.
• Attach the toy bar, if desired (see steps - ).
Restraint
Buckle Buckle
Battery Compartment Door
• Lift the footrest wire. Remove the pad from the footrest
wire with soothing unit.
• Insert a coin into the the battery compartment door and
pry the battery compartment door open.
• Insert one size “D” (LR20) alkaline battery, as indicated
inside the battery compartment. Be sure to place the
battery on top of the ribbon.
Hint: For easy battery removal, simply lift the ribbon.
• Replace the battery compartment door and be sure it
snaps securely closed.
• Fit the pad onto the footrest wire with soothing unit.
• Lower the footrest wire with soothing unit.
Battery Installation Securing Your Child
To prevent serious injury and/or falls:
• Always use the restraint system.
• Never use with a child able to sit
upright, unassisted.
WARNING
Please Note:
• Remove the battery during long periods of non-use.
Never leave a worn out battery in the Deluxe Soothing
Bouncer Seat. Battery leakage and corrosion can damage
this product. Dispose of the battery safely.
• Do not attempt to recharge a non-rechargeable battery.
• Remove a rechargeable battery from the Deluxe Soothing
Bouncer Seat before recharging.
• Charging of a rechargeable battery should only be done
under adult supervision.
• Avoid short-circuiting the terminals of the battery.
• Remove the exhausted battery from the Deluxe Soothing
Bouncer Seat.
5
79

OFF ON
®
• Make sure your child is properly secured in the Deluxe
Soothing Bouncer Seat.
• Slide the ON/OFF switch on the soothing unit to the
“ON” position. The seat will vibrate.
• Slide the ON/OFF switch on the soothing unit to the
“OFF” position. The seat will not vibrate.
• Remove the toy bar from the seat back wire.
• Lift the footrest wire with soothing unit and remove the
pad lower pocket.
• Slide the pad upper pocket off the seat back frame.
• Remove the seat back wire from the left and right
base wires.
• Remove the footrest wire with soothing unit from the left
and right base wires.
• Remove the battery from the soothing unit.
• Remove the left and right base wires from the base tube.
• Store all parts in a safe place for future use.
Soothing Unit
The pad is machine washable. Wash the pad separately in
cold water on the gentle cycle. Do not use bleach. Tumble
dry separately on low heat and remove promptly. The wire
frame, toy bar, mirror, paddles and rings may be wiped
clean using a mild cleaning solution and a damp cloth.
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York
14052, warrants that the Deluxe Soothing Bouncer Seat is free
from all defects in material and workmanship when used under
normal conditions for a period of one (1) year from the date
of purchase.
Should the product fail to perform properly, we will repair or
replace it at our option, free of charge. Purchaser is responsible
for shipping the product to Fisher-Price Consumer Affairs at the
address indicated above and for all associated freight and
insurance cost. Fisher-Price, Inc. will bear the cost of shipping
the repaired or replaced item to you. This warranty is void if the
owner repairs or modifies the product. This warranty excludes
any liability other than that expressly stated above including but
not limited to any incidental or consequential damages.
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMI-
TATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES,
SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT
APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS,
AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH MAY
VARY FROM STATE TO STATE.
• The canopy can be adjusted down or up.
• Fasten the snap on each side of the canopy when using the
canopy in the raised position.
OFF ON
OFF ON
Canopy
Down Canopy
Raised
Snap
Snap
Use
Storage
Care
One Year Limited Warranty
OFF ON
®
Canopy
Sleeves
Canopy
Stays
6
If you have any questions about this product:
In Canada, call 1-800-567-7724, or write to: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2. In Great Britain, telephone [phone]. In Australia, call the
Australian Consumer Advisory Service toll-free at 1-800-800-812, or write to: Mattel Pty. Ltd.,
658 Church Street, Locked Bag #870, Richmond, Victoria, 3121 Australia.
1
2
To remove the pad:
• Lift the footrest wire with soothing unit and remove the
pad lower pocket.
• Slide the pad upper pocket off of the seat back frame.
• Remove both canopy stays from the canopy sleeves.
To re-assemble the pad:
• Refer to assembly steps and .56