Fisher-Price H4788 User manual

1
1
Instructions
Model Number: H4788
Please read these instructions before assembly and use of this product.
Adult assembly is required. Tool needed for assembly: Phillips Screwdriver (not included).
Requires four “D” (LR20) alkaline batteries (not included) for operation.
Product features and decorations may vary from picture above.
www.fisher-price.com
WARNING
IMPORTANT! KEEP FOR FUTURE REFERENCE.

WARNING
Parts
IMPORTANT! Please remove all parts from the package
and identify them before assembly. Some parts may be
packed in the pad. 2 Toys
#8 x 2.22 cm Screw – 2
All Shown Actual Size
Note: Tighten or loosen all screws with a Phillips
screwdriver. Do not over-tighten.
#6 x 2.86 cm
Red Shoulder Screw – 2 M5 x 20 mm Screw - 2
To prevent serious injury or death:
•It is dangerous to use this reclined
cradle on an elevated surface, since
child's movement may cause infant
seat to slide or tip over.
•Never use on a soft surface (bed,
sofa, cushion), since seat can tip over
and cause suffocation in soft surfaces.
•Always use the restraint system.
•Never leave the child unattended.
•Never use as a car seat.
•Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg (20 lbs).
•To prevent the massaging rollers from
contacting baby’s head, use only for a
baby weighing at least 2.3 kg (5 lbs).
CAUTION
This package contains small parts
in its unassembled state.
Adult assembly is required. 2 Feet
Left Base Wire
Liner
Right Base Wire
Base Tube
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NewYork 14052, U.S.A.
©2004 Mattel, Inc. All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA H4788pr-0726
Pad
GREAT BRITAIN
Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500302.
AUSTRALIA
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870,
Richmond, Victoria 3121 Australia. Consumer Advisory Service
1300 135 312.
ASIA
Mattel East Asia Ltd, Room 1106, South Tower,
World Finance Centre, Harbour City, Tsimshatsui, HK, China.
MALAYSIA
Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd. (993532-P)
Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran Tropicana Golf
Country Resort, 47410 PJ. Tel: [phone], Fax: [phone].
Consumer Information

1
2
Assembly
Right Base Wire
Feet Holes
Footrest Wire
Base Tube Holes
•Position the feet so the holes are toward you and the non-skid
surface is down.
•Fit the feet on the base tube, as shown.
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing or broken. Contact
Mattel for replacement parts and instructions if needed. Never
substitute parts.
•Place the base tube on a flat surface, with the holes facing you.
•Position the left and right base wires as shown.
•Fit the left base wire and right base wire into the base tube.
Left Base Wire
3
3
•Insert an M5 x 20 mm screw through each foot and tighten.
M5 x 20 mm Screw - 2
4
•Place the liner on a flat surface with the soother unit facing you.
•Lift the footrest wire and rotate it toward you until it is on
the surface.
•Turn the liner over so that the soother is upright.
Liner
Soother Unit
Soother Unit

Assembly
4
•Fit the base wires into the slots in the retainers on the liner.
Push the retainers down.
Base Wires
Retainers
5
6
#8 x 2.22 cm Screw – 2
Retainer Lower Hole
•Insert a #8 x 2.22 cm screw through the lower hole in each
retainer and the hole in each base wire. Tighten the screws.
•Pull up on the retainers to be sure they are secured to the left
and right base wires.
7
Footrest Wire/
Seat Back Tube
Groove
•Fit the footrest wire/seat back tube into the groove in
the retainer.
Footrest Wire/
Seat Back Tube
8
#6 x 2.86 cm
Red Shoulder Screw – 2
•Insert a #6 x 2.86 cm red shoulder screw through the seatback
tube, footrest wire and into the retainer. Tighten the screw.
Hint: You may find it easier to tip the assembly on its side to insert
and tighten the screw.
•Repeat this assembly step to secure the other end of the footrest
wire/seat back tube to the other retainer.
•Push down on the seat portion of the liner to be sure it is secure
to the retainers.

5
Assembly
9
Pad
Pad
Bottom
Pocket
Liner
10
•Pull and fit the pad seat
bottom pocket around the
soothing unit and footrest.
•Fit the restraint straps
through the slots in the pad.
•Fit the pad into the liner.
Restraint Straps
11
•Attach the fasteners at the top and sides of the pad.
Toys
12
•Fit any of the toy straps through a toy ring. Now, fasten the
toy strap.
Assembly is now complete.

1,5V x 4
LR20 (“D”) +
_
6
Battery Installation
1
2
Hint: We recommend using alkaline batteries
for longer battery life. Soother Battery Compartment Massager Battery Compartment
Pad Bottom Pocket
•Remove the pad bottom pocket from the footrest.
•Locate the electronic unit on the footrest wire. You will see that
there are two battery compartments. The smaller compartment
powers the soother; the larger battery compartment powers
the massager.
•First, loosen the screw in the soother battery compartment door
and remove the battery compartment door.
•Insert one “D” (LR20) alkaline battery into the battery compartment.
•Replace the battery compartment door and tighten the screw.
•Next, loosen the screws in the massager battery compartment
door and remove the battery compartment door.
•Insert three “D” (LR20) alkaline batteries into the battery compartment.
•Replace the battery compartment door and tighten the screws.
IMPORTANT! Low battery power may cause this product to operate
erratically (no sounds/vibration/massage) and the product may not
turn off. Remove and throw away all four batteries and replace
with four, new “D” (LR20) alkaline batteries.
Shown Actual Size
Battery Safety Information
Batteries may leak fluids that can cause a chemical burn injury
or ruin your product. To avoid battery leakage:
•Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
•Insert batteries as indicated inside the battery compartment.
•Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of batteries in a fire.
The batteries may explode or leak.
•Never short-circuit the battery terminals.
•Use only batteries of the same or equivalent type
as recommended.
•Do not charge non-rechargeable batteries.
•Remove rechargeable batteries from the product
before charging.
•If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.

7
Setup and Use
1Restraint Straps
Securing your Infant
•Place your child in the seat. Position the restraint pad
between your child’s legs.
•Fasten the restraint straps to the restraint pad. Make sure you
hear a “click” on both sides.
•Check to be sure the restraint system is securely attached
by pulling it away from your child. The restraint system should
remain attached.
Restraint Pad
Free End Free End
To tighten the restraint straps:
•Feed the anchored end of the restraint strap up through the
buckle to form a loop . Pull the free end of the restraint
strap .
To loosen the restraint straps:
•Feed the free end of the restraint strap up through the buckle
to form a loop . Enlarge the loop by pulling on the end
of the loop toward the buckle. Pull the anchored end of the
restraint strap to shorten the free end of the restraint strap .
Anchored End Anchored End
2TIGHTEN LOOSEN
WARNING
To prevent serious injury or death:
•It is dangerous to use this reclined
cradle on an elevated surface, since
child's movement may cause infant
seat to slide or tip over.
•Never use on a soft surface (bed, sofa,
cushion), since seat can tip over and
cause suffocation in soft surfaces.
•Always use the restraint system.
•Never leave the child unattended.
•Never use as a car seat.
•Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg (20 lbs).
•To prevent the massaging rollers from
contacting baby’s head, use only for a
baby weighing at least 2.3 kg (5 lbs).
IMPORTANT! Before each use, inspect this product for damaged
hardware, loose joints, missing parts or sharp edges. DO NOT use if
any parts are missing or broken. Contact Mattel for replacement
parts and instructions if needed. Never substitute parts.

Soother and Massage
• Make sure your child is properly secured in the seat.
Slide the vibrations switch:
Vibrations On
Off
Note: If vibrations become faint or if there are no vibrations, remove
the battery from the small battery compartment and throw it away.
Replace the battery with a new, “D” (LR20) alkaline battery.
Slide the sound switch to choose:
Lullabies Music
New Age Music
Nature Sounds
Off
Note: Music/Sounds turn off after approximately 8 minutes. To turn
music/sound back On, slide the sound switch Off and then to the
desired On mode.
Slide the massage switch:
Massage On
Off
Massage unit runs for 8 minutes – massaging baby for 20 seconds, resting
for 5 seconds, massaging baby for 20 seconds, etc. To restart for another
eight minutes, press the reset button .
Note: If sounds or massage become faint or if there are no sounds or
massage, remove the batteries from the large battery compartment and
throw them away. Replace the batteries with three, new, “D” (LR20)
alkaline batteries.
8
•First fit the restraint belts back through the slots in the pad.
•Pull the pad bottom pocket off the footrest.
•Lift the pad off the liner.
•To replace the pad, refer to Assembly steps 9 - 11.
•The pad is machine washable. Wash it separately in cold
water on the gentle cycle. Do not use bleach.
Line dry only.
•The frame, toys and liner may be wiped clean using a
mild cleaning solution and a damp cloth. Do not use
bleach. Do not use harsh or abrasive cleaners. Rinse
clean with water to remove residue.
Care
Reset Button Massage Switch
Vibration SwitchSound Switch