Assembly instructions for UPPLYFT Wall Bars
GENERAL:
Always fasten the screws slowly and firm. However, do not mount the screws too
deep and tight. Remember, that the material is wood, and may crack if you are
using too much power. Once the Wall Bars are fully assembled, check that all
the screws are fully fastened.
Step 1
Step 2
Cover the floor so that the
floor or Wall Bars will not get
scratches. Lay the first long
wooden side rail on the floor.
Fit all the oval bars into the
long side rail. Use a rubber
mallet and carefully tap the
oval bars in place if it is
necessary. Bars are meant to
be tight.
Fit the second rail on the top
of the oval bars. Start at one
end and progressively insert
oval bars until all are seated.
Use wooden block and rubber
mallet if necessary to fully seat
oval bars.
Be careful not to damage or
scratch the surface. Screw
four oval bars to the wooden
sideboards with four (4 pcs) 6
x 80 TX 25 screws on the one
side.
Turn the Wall Bars on the other
side and screw the oval bars
with the next four (4 pcs) 6x80
TX25 screws.
