Flash Furniture ET-BT3503-18-BL-WD-GG User manual

Thank you for your purchase!
Customer Service Email: [email protected] | Phone: [phone]
Metal Dining Stool
with Rustic Walnut
Wood Seat
ET-BT3503-18-BL-WD-GG / ET-BT3503-18-BLK-WD-GG / ET-BT3503-18-ORG-WD-GG / ET-BT3503-18-PR-WD-GG
ET-BT3503-18-RED-WD-GG / ET-BT3503-18-SIL-WD-GG / ET-BT3503-18-TL-WD-GG
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The
tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/ET-BT3503-18-PR-WD-GG.pdf

A :
B :
C :
1
D :
1
2
1
A
B
C
D
√
×
Wooden Seat
Mounting Bracket
QTY QTY
QTY QTY
Screw
Allen Wrench
C:
Stool
STEP 1A: Place Wooden Seat (Part A)
face down on a clean, smooth surface.
Turn Metal Stool (Part C) upside down
onto Wooden Seat.
Cupped side down
Cupped side up
NOTE: Ensure pre-drilled
holes on the underside of
Wooden Seat are visible
through the stool seat hole.
Wooden Seat
Allen Wrench
Screw
Mounting Bracket
Pre-Drilled Holes
STEP 1B: Place Mounting Bracket (Part B) with
cupped side down into stool seat hole and place over
pre-drilled holes in the wooden seat. Attach using (2)
Screws (Part C) and tighten with Allen Wrench (Part D)