Flash Furniture NAN-JN-2966-GG User manual

Thank you for your purchase!
NAN-JN-2966-GG
Computer Table
Customer Service Email: [email protected] | Phone: [phone]
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The
tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Philips screwdriver (Not Included) required for assembly.
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/NAN-JN-2966-GG.pdf

Cam Lock
Covers
Cam
Lock
Screw-In Pin
M6x30x6
Bolt
M6x12x2 Bolt
M6x55x6 Bolt
Leg Braces
STEP 1A: Lay Desktop face down on a smooth, clean surface. Attach Steel
Frame Left and Right to underside of desk shelf using (4) M6x30x6 Bolts (Part 3)
and to Middle Connector using (2) M6x55x6 Bolts (Part 2). Tighten using Allen
Wrench (Part 6).
STEP 1B: Attach Leg Braces to Left and
Right Legs using (2) M6x30x6 Bolts (Part
3) and to Middle Connector using (2)
M6x12x2 Bolts (Part 4). Tighten using
Allen Wrench (Part 6).
Desk Shelf
Middle Connector
STEP 2: Attach Left Side Panel and
Right Side Panel to Desk Shelf
using (4) M6x55x6 Bolts (Part 2).
Tighten using Allen Wrench (Part 6). Desk Shelf
M6x55x6 Bolts
STEP 3A: Insert (4) Screw-In Pins
into the connectors on the underside
of the glass desktop. Turn clockwise
to tighten.
STEP 3B: Insert Cam Locks
(Part 1) into the inner holes on
the Left and Right Side Panels.
Connectors
Screw-In Pins
Cam Locks
Desktop
Cam Lock Covers
STEP 3C: Insert (4) Screw-In
Pins into the Left and Right Side
Panels. Using a Philips
Screwdriver (Not Included) turn
Cam Locks to tighten.
STEP 3D: Insert (4) Cam Lock
Covers over Cam Locks.
Allen Wrench
6