Flash Furniture BL-X-5M-D-GG User manual

 u  yo e!
Mid-Back Mesh Drafting Chair with Adjustable
Foot Ring and Flip-Up Arms
ASSEMB INSTRUCTIONS
Before You Begin:
 


Caution:
 


Warning:
CHOKING HAZARD 
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE





Customer Service Email: CustomerE[email protected] I Phone: [phone]
BL-X-5M-D-GG/BL-X-5M-D-DKGY-GG/BL-X-5M-D-WH-GG/BL-X-5M-D-RED-GG/BL-X-5M-D-BLUE-GG/BL-X-5M-D-BK-LE A -GG


 


 


until fully tightened.
(Part 5) using (4) M6x25mm Bolts Left Arm (Part 6) Right Arm (Part 7)
(Part A) (Part E) (Part A).
NOTE: DO NOT CROSS THREAD SCREWS.
If screws start to tighten before parts are
securely together, remove screw and try again.

(Part F) (Part G) (Part 6) (Part 7)
(Part 6) (Part 7) (4) M6x35mm Bolts (Part C)(Part 4)
and (4) Flat Washers (Part D).
(Part E)(Part C)
6
7
NOTE: DO NOT CROSS THREAD SCREWS.
If screws start to tighten before parts are securely
together, remove screw and try again.

(Part B)
(Part 4) using (4) M6x40mm Bolts (Part B)
(Part E)
NOTE: DO NOT CROSS
THREAD SCREWS.
If screws start to tighten
before parts are securely
together, remove screw and
try again.